Viewing all customer Discussions for:

Lavatory

My current framed shower door drip rail is 24 inches at the shorter end (closest to shower door glass) but about 25.5 inches at the longer end as 1.5in overhangs. Will your 24-inch sweep with drip rail work in this configuration?

Hollow seal for Sterling 1500 D shower door

What is the thickness of your clear decorative star rosette product code 10-012. It is listed with height of 1 1/2" and hole diameter of 3/16". Another question: do you have a 2" star rosette. If yes, please provide the thickness and hole diameter of the 2" rosette. Also how much a piece and disco ... (cont.)

Looking to replace 40 year old plastic shower door guides that fit in bottom of door to allow doors to glide and stay separated.Doors are 1/2" thick, 22 3/4" wide, and 64" high.

Hi, really need assistance finding the correct part for this old shower door as the original part was removed before I saw it.

NEED REPLACEMENT GLIDES FOR CURVED DOOR FOR WASANA STEAM SHOWER THE NUMBER I FOUND ON THE GLIDER IS DZ01389R PLEASE LET ME KNOW THE AVAILABILITY AND IF YOU CAN SHIP TO CANADA OR YOU HAVE A DISTRIBUTOR HERE.

For glass shower door. Need something close to it. Or something universal that is similar.

Got a bit too enthusiastic about recaulking my shower doors and one of these snapped off while removing the doors. Seeing as they're from 2003 I might as well replace all 4...is this the right part to order? And do I need to get the side screws or should those be ok?

NEED SHOWER DOOR GUIDE AND 6 BUMPERS.INFORMATION FROM BOTTOM CORNER OF GLASS SHOWER DOOR:UNITEXANSIZ97.1-198416CFR1201 11SGCC 25 75 1/4UThank you for any help.Sharon

Purchased glass shower doors that are 1 inch too short. Need to know if you have Hanger Brackets that can adjust to 1 inch longer than what came with the doors (see pictures).

Do you have piping (about 3/16" height 1/16 width that goes between glass and frame of framed shower doors?

Need replacement parts and screws for framed shower door. 21 1/2 inches long and Drew's are 2"" from each end

My handyman installed this shower door sweep and left a 1 inch gap between the rubber and the bottom of the shower door where it touches the tile and closes. Did he install it incorrectly? Shouldn't it touch the tile to stop the water? Not sure if I'm explaining it correctly but it seems like it sh ... (cont.)

Loiking for 10 1" 1/4 shiwer wheels similar to the attached image.

I need to replace a broken clip from the bottom of a sliding glass shower door. Do not know the brand or model #. Corner shower enclosure approximately 3'x 3'

Are the 10-061 rollers supposed to go on the top or bottom of the shower door? Thanks! Jordan

I am also looking for the bar that comes with these handles.

I have two sets of shower/tub doors that will use this guide. Neither one has the "existing spacer" your instructions refer to. Will that be something I will need to get for installing these? 10-139 Thanks, Jeff

Door 16 cfr 1201cii. One of that plastic piece that holds door In place when they slide broke. I. Need to. Replace them. Both. Can you help. Me find that part.