Viewing all customer Discussions for:

Lavatory

Aluminum bar with rubber sweep. looks like your 30" shower door sweep with drip rail. bar is 27-1/2" long and 1" wide Has three mounting holes in bar, each end hole is 3-1/4" from the ends, the middle hole is 13-1/4" from the left end. it's off a folding shower door. I would have sent a picture ... (cont.)

I recently purchased a 10-332 frameless shower door sweep from you. Now that I have the time to replace the old one (which is all filled with unsightly fungus), I see that it is very closely adherent to the shower door, and very difficult to remove. Do you have any suggestion about how to go about ... (cont.)

I am looking for the attached bit of hardware. I have viewed you 10-152 the measurements are the same. Except your roller is set on a flat plate and mine on an angle. Would this make a different when installing. Thank You.

I need a new set of rollers and hardware for the top

The door locks that I ordered were the wrong ones. They were :(2) 10-561 : Lever Handle Assembly, ADA Compliant. The one that is needed is a Globe ADA and the only number that could be found on it is 1. It is from about 1995 when it was installed at our church.

This insert connects to a handle in the other side of the door, do you have the handle also?

Shower roller for glass curved shower doors

See attached photo. It is a dual towel bar. Please let me know if you have it in stock

I need help finding a sweep for this 35 year old door. The frame measures 23.5 inches wide. The door is .5 inches thick.

Shower door seal

How wide is it? I bought one that was 5/32" and it was too thick to slide into the grove of the shower door.

Greetings, I am trying to locate these shower door replacement parts. Any help would be super helpful. Best, John

I'm looking for a shower sweep. The shower door has no frame. The sweep measures 24" total but 22" attaches to the door.

not sure if this is user error or maybe I need another product I installed the below product and am not getting a good seal. I matched what the previous home owners installed on their door....i thought i leaked because it was badly worn. upon closer inspection, the door swings OUT and pulls the w ... (cont.)

I have a framed shower door that has a plastic sweep that needs to be replaced. I'm having trouble finding the correct part. It appears to just slip on the glass (1/4 inch thick) and has a drip rail on the inside to direct water away from the base of the door. The sweeps I have seen appear to be for ... (cont.)

Please find attached the picture regarding the part for the shower. Thank you. Kind regards, Aleisa

How many fastener holes are on this drip rail? Would like to know how many 33-071 screws to buy but this information is not stated in the description of the drip rail.

How much floor clearance do need?

Unitex ANSI Z971-2004 SGCC-25763/84 The bottom slider to my shower door cracked and I need to replace how do I get a new one. Please advise Patty Thank you

I ordered a 3/8" shower sweep but unfortunately my shower glass is 3/16 not 3/8 as originally thought. Can I return these and what size should I have ordered as I do not see one for 3/16 inch glass?