Viewing all customer Discussions for:

Other

I have some older louvered style windows in a shed that I need to find replacement crank handles for and possibly the geared operator that the handles attach to for some of the windows. I measured the splined shaft that the handle attaches to and it looks to be very close to 5/16 diameter. It also ... (cont.)

This is the same as another windows operator that is broken. I can get some info from the crank and window but not the operator, so I need to know what part number I can use to replace it. Any help would be really great, thank you!

I am looking for two latches and two 90 degree angled lock plates as shown in attached photo... please advise...

I am looking for the mortised latch for a Pella Stormdoor. Attached is an image of what I have. On the edge of the door is printed this #P6400332152140925 Thanks Steve

please help me to identify the part

Need replacement with the handle OP06-7509-00 I can't find one on your site with the handle and not sure how to take off the handle from my old one, can't find the usual hex screw on it, Thanks

Understanding this rail bracket discontinued. How can u help as it is broken

Needing to purchase this balance. Metal piece measures 25-5/8". Overall length 27". 25 5 stamped on the side.

Which part number is this?

Hello,My name is JustinI am trying to replace the balancers for two identical older Anderson windows. I followed the instructions in your video to open the top jam liner and found the Balancers but I am not positive about the part number. It looks like it's 927 but I am hoping you can confirm this ... (cont.)

Hello,I have 14 year old windows made by Kinco. Single-hung, non-tilt, 1/2 inch channel width. I took out the window, and it weighs 28 pounds. The balancers have a block and tackle system that the string goes through. Channel balance is 35 inches long (metal part only - plastic ends not counted)... ... (cont.)

Could you help me find the correct part to match the attached picture. Windows are Simonton.

Trying to ID this coil type balance. The closest thing I can find is a roller tilt, they are not the same.

Just need latches pictures above car# 138-725 model 8100 sing hung with fin

Dear Swisco, I need DUAL ARM OPERATOR, SILL MOUNT for my home in Kauai. Attached are photos of the assembly. Please let me know what to order. I need about 10-12 full replacement assemblies in white, right side crank. Thank you, Irv Blitz

3/4" deep 6.5" Long 1" wide 12" long Rod

The window pivot mechanism is for a revere vinyl replacement window manufactured 09/07/12. The pictures of the part, the length is 1 7/16th inches without the spring, 3 5/8th inches including the spring. The width is 1 3/16th inches and 1 1/2 inches thick. The supplier of the windows provided a mode ... (cont.)

This is the front & back side of a balance I'm trying to find. Any assistance would be greatly appreciated.

Need night latches, tilt-in catches and cams. May need complete balances?

I'd like to replace these lock levers on Pella casement windows that were installed in 1983. The prior owner painted over many of them and my attempts to clean them have not been completely successful. I'm looking for Champagne if available. Thanks, Audrey