Viewing all customer Discussions for:

Other

Looking for replacement for this. Thank you! Need ASAP

It is shaped like a cube with one side missing

Can you let me know the part number and if you have the part to get it replaced?

Hello, Are replacements available for this design? I need a bag full of these please. Thank you

29 inch width shower door handle bar screws mount in the back door frame one screw on each side U shape blend is plastic b

Do not have manufacturer identified on windows only "compliance" sticker. Have one broken latch and would like to purchase several replacements for current and future repairs

I need 1 left and 1 right

Good Afternoon, We are looking to replace the window pivot blocks and constant force springs on both sides of the window. The Window weighs 24 lbs. for that pane. The springs are 1/2 inch deep, and 1 1/8 inches wide. There are two springs per side, and they have j hook ends. They are stamped with ... (cont.)

Marked on the bottom LH 45135 The arm is marked 40051B

I have NORCO windows in our home that is 14 years old and many of my cranks and other parts are broken. D series clad case/awn, JEL-N-330. Do you sell these parts?

I think these are from a mid 90's home improvement project. There are no markings on the windows or frames. Interior screens, the windows wind out.

I need to find a compatible pivot bar for my single-hung, tilt vinyl window. The broken one measures 3-1/4" total length, the broken end is 3/8" long, and the 2 screw holes are at 1-5/8" and 3".

Hi,I have 10 top sashes that need replacing and I'm thinking I may be able to use the 18-015 for PGT windows 1988 models.Please advise if this is the correct part.thanks so much,Paulette

Need pricing on 40 - Ultra-Lift Balance 21 " * 24lbs

Need to replace Blum cabinet hinge. It says 110 degree, 1 1/4", 213, also has 34.355-01.01 stamped on it.

I have Series 0201 Double hung PL# 004-011 windows, one of which has defective coil balancers. Can you direct me to the correct replacement parts. I believe it is an Alside window.

The arm is 13.5 inches from the center of the gears and to the center of the detach clip. The body is 5 inches wide and 2 3/4 inches high There's no numbers or descriptions on the device

Pella door gasket door #0501 PLCSCVF1Z1-072A081AWHT-615S-NFRC

There are no markings on the current ball bearing slide. it is from a chest of drawers, center mount under the drawer. the inner slide is 14 5/8" long x 1 3/8" wide, the outer slide is 16" long x 1 3/4"wide, the inner slide has a screw mounting tab on each end.

Left channel for nuprime windows .channel is 24.5 inches long ( measurement from top to bottom all metal) .I need complete channel. Can you help me.