Viewing all customer Discussions for:

Other

I have one that is operable and the other one is broken. I would like to make sure I am ordering the right part. Any help would be appreciated. It is printed with 2930 But I am not sure if I need a 5/8 inch or half inch guide. Thank you for your help

Looking for this part.

Good morning! I need to locate the parts to repair a window that was installed a few years ago that did not have the tracks installed on it for the operators. The daylight on each is 18" for the glass, the casements are around 22" each which give it around a 48" outside to outside of the window. ... (cont.)

Hello there.I'm gonna need balances for my windows. I would like to replace them all. The side stamps say 27~30 and I included pictures of one from, I hope, all angles. I believe I can handle the project. Not all windows need replacement but I will do it. Please let me know if you carry this product ... (cont.)

I have Truth brand openers 30841L, 30842R. It looked like I needed 39-035 and 39-036 of your openers. But the piece that goes to the linkage on top is straight, and mine has a slight bend in it. Will this make a difference or do I have the wrong opener picked out? Thanks in advance for your help. ... (cont.)

Need 2 new channel balances 34 4 FW CMC 10 Need 2 new channel balance heads

I need to find rollers for RiteSceen sliding screen(for a sliding glass door screen.

I am looking for replacement balance for Plygem 1100/1200 SH single hung window balance. Width of shoe is 1 inch and height of Spring attached rod is 31 inches. Weight of window is around 15 pounds.

Side mount and search that attach to the springs before lifting the window

I have several PGT SH-4000 single hung windows requiring balance replacement. Based on measurements and my pictures with measurements, would S395-30 be correct? The markings I see are: * 29 4 IV CMC 2 * 29 5 DW CMC 4 * 29 6 FW CMC 11 There are no stamps. One sash weighed about 27.4 lbs. Would Option ... (cont.)

How can I purchase a window coil balance part for an Alside sliding window? I'm in Hawaii. Let me know the cost and shipment cost.

Someone broke the left side corner attachment that the tilt window slides up and down and tilts on. After lots of googling I think that it's called a pivot shoe. I know it's not a great picture but can you identify it for me for replacement? You have so many and I don't know which one to purchase. ... (cont.)

Is part #82-005 available in white? I actually only need this part because the other pieces are still fine but I'll be happy to purchase the whole kit if necessary.

Rv screen clip.

The arm is 4.5" and not odd set.

The crank handle says us pat 4083264 Can pat 1979 And then 45012 on the right corner

The satin nickel finish on these parts for my Marvin windows has worn off due to the sea air.

Wheel for bottom of slider

Aloha. In the house we purchased this sliding door is missing the latch part. Please see attached photos thanks

I need two replacement units for Semco casement windows. the gear unit is stamped with the number 45179 and the operator arm is stamped with the designation "L 31538". Thank you. Richard