Viewing all customer Discussions for:

Other

Hello I try to find this part but I don't know where to buy

This part has a little elevation but only connect to a small wooden piece on the dresser.

The window assist are broken, the lead keepers are busted out of holders that help lift window. One picture shows the lead keeper holding the rods which are connected to slide. Hoping you can help me out, thank you Don

part number f-1040-67 Right side where can i buy this part

It says Anderson

Replacement window cranks The information on the crank is D-198202us/RD 1963 3" RH 11529 If you carry the replacement I will need RH and LH let me know if you need more.

I need two replacement coil balances. There are not marking on the broken balances. The window itself weights 19.5 lbs. It is a Capital 3500 Series Vinyl Window. The photos show the broken units with a ruler, operational units, and the tilt bar at the bottom of the window.

Looking to order replacement part /assembly for rubber gasket strip that attaches to the bottom of the door to seal off drafts and moisture

Several windows are missing these short valance track covers and I have to replace the dogging device in these tilt out windows. Looking for 10 more snap coversPlease AdviseThank youDavid

Rollers are 1 1/2" diameter with an eccentric roller axle that allows for door adjustment. There are 2 rollers on bottom and top. The bottom of the door is 5/8" wide and 1 7/16" deep. Please advise on repair and parts needed. I do not see any replacement on web site but open to suggestions. These ar ... (cont.)

There is no marking, just says Mastic window. They are broken off of 6 windows or a total of 12 parts. It is very difficult to open the windows with this broken park. Please help me find this part. Thank you, Barbara

Need replacement parts or part numbers

I am looking to replace the top plastic piece shown here along with the plastic piece shown next to the dime. This piece sits at the top of the spring. I need 3 of each of these pieces.

Hopefully the pictures will help identify sash 1/2 x 27 Thanks Bill

need 2 outside key locks.

Hey I have several windows I will need to replace these balances and I was having a hard time finding them on your website. I know they are there I'm just not good with computers Thanks, Lucas

These are off my slider doors . I m looking for new ones . I need 3 set for all my patio doors. The condo people said these were built in the 1965- 1970 . Any help I can give u let me know . They are 2.5 long about 3/4 wide and about 1 inch across .

Looking to replace double latching lockI have a slider that is unmarked and I am looking to replace the double latch lock that broke. I only need the locking mechanism but I have no way of identifying it. Can you please help? Adam

Mechanism is no longer operable. Looking for replacement

Looking for replacement window rollers as shown in picture. Base is 3/4" X 1 1/4". the height to the top of the roller is about 5/8". Do you have a matching replacement. Looking for 4. Thanks