Viewing all customer Discussions for:

Other

Need to know what type it is

metal channel is 25 5/8

The lock that stopped working is in door frame. When trying to take out it fell inside

Flat top. 3/4 inch diameter, 1/8 inch height. Goes on the front piece of wood to the dresser

Can you please help identify the direct replace part. Thank you.

This latch is from an Atrium sliding glass door that was installed in 1999. I would like to know which replacement part(s) would work.

I've been replacing my drawer guides every couple years, they don't seem to hold up very well. I use the Prime Line 7321 kit. The guides replaced the original glides that came on the furniture. What guides would I use from your company that wouldn't require changing the tract?

Seems to be 1/2" wide , 33" long

Marvin tilt out double hung 36x60 inch wood inside metal outside date mfr about 1997 (placed in house) 30 years old. , vinyl cover foam inside has spline to fit into a spline grove.

none of the pivot bars shown on this site look like my simonton window pivot bars. mine are 3" long and are straight.

I am trying to locate the correct replacement part this handle, lock, latch and catch. The screw holes on the handle are approximately 4 1/8 on center

I have a broken latch I'm trying to replace. The photo above is the good one. The measurements are as follows: 2" screw to screw 3 1/2" overall length 1" wide 3/4" from latch side to screw hole

Looking for a replacement I have a couple broken windows

The latches are two parts one slides into the other spring is missing, part latch end section broken off to secure window. Both piece are brittle and left and right assembly are needed for 5 windows and 4 screen assembly's . Thank in advance. The windows were pre 2015 era . I believe they could be 2 ... (cont.)

Need to know if you can make one or if you have one

Do you have a latch cover that is compatible with a Pella sliding window?

I need to replace a broken support bracket for the back side of the RIGHT rail of my kitchen drawer. The photos that I uploaded show the bracket with some small missing pieces on the bottom and upper left of the bracket where it broke.

Need 1 of these for Penn Co windows.

I do not know the weight of the window. The the balances are printed with 86 17-4 GA5 CMC 1.I have replaced others but there are 2 odd ball windows with these balancers that I want to replace. Thank you, Brian

Need new weather striping for 10 double hung 30 year old Marvin Integra double hung windows..