Viewing all customer Discussions for:

Other

I need to find pulls like this. I need 15-20

Hi, Can you please help me find the right channel balance. I have 3 window sizes. The large Window metal part measure 33" and tab on metal label "3330/", the medium window metal part measure 28.5" and tab on metal label "3330". The small window I cannot find the old channel balance. I only can meas ... (cont.)

I have a simonton window. The bottom part (shoe?) Broke off, I need 4 replacements. Id like a complete set of pivot and shoe as it seemed to break from weather degradation (brittle from cold exposure)

Do you have a replacement solution for this part?

Need help identifying and sourcing replacement hinges(?) for my awning windows. The parts are marked as left and right. I need a minimum of two right hand pieces.

The sliding drawer back right bracket from one of our Mastercraft drawers broke. Do you recommend a replacement please?

Hello, I've been trying to identify and replace this part of our bifold pantry door but have no luck. Any help you can lend would be greatly appreciated!

Bi fold mirror closet door plastic rollers worn away

Hello, I recently purchased 2 replacement rollers (81-018) and a track cover for my patio door. This is the existing weather stripping, which has deteriorated. The fabric stripping slides over the track and the rollers push thru it to contact the track. Do you have anything I could use to replace ... (cont.)

please advise which of your 25 foot kerf mount bubble seal 5/16" would be appropriate. thanks.

Hello, I was just curious if I could make my existing door handle have a lock from outside or if not, if the handles you sell would work in my door. I'm not sure what the door brand is. We just purchased the house and it was already installed. Some of the other windows that look similar are Ply Gem. ... (cont.)

Howdy!" We just purchased a condo with a broken (actually, missing) lock for the sliding patio door. We have determined (we think) it is a Peachtree Carvel model based upon the handle design. We have removed the handle set - interior & exterior - and have attached photos here. The "guts" (the latch ... (cont.)

This clip is thin. I have a piece of metal 1/32 inch thick which appears to be the correct thickness. Your standard Miami Window clip seems to be the correct shape, with a 3/4 inch shank, just too thick. These windows were installed in 1959. I could use 100 pieces.

I have a left hand crank operator of which I'm not sure who the manufacturer is. I can open the window but I can not close the window. The auger which meshes with the gears can be removed as you can see from the photos. I don't think this is the way it's supposed to be. There seems to be a small chi ... (cont.)

Hi, The roller has a 1.5 in diameter. It is a bit smaller than the Home Depot generic replacement in that the bottom of the slider is a bit to small in width and depth. The old part measures at 0.735 in in width and the 3 5/8 " in length (excluding the wheel mechanism). Markings are "PRODUCTION E ... (cont.)

Hello, I'm looking for a replacement pull handle for our kitchen drawers. The manufacturer is Arrital. See photo. The the screw thread inside the handle are worn out and often come undone. Do you carry this? Or know where I can find it? Thanks, Randy

I am looking for a 30"w x 12" or 13"h scheirich oak cabinet. Can you help me? Thank you

What is this and where can I get it

It say 110 34.355-01.01

Good Afternoon, I am looking to find these window locks from 1980s, single pane windows Any help is appreciated. Thank you.