Viewing all customer Discussions for:

Other

I'm looking for a replacement window spring for a single hung window. the following numbers and letters were on the part: 24 3 bs 1

I'm pretty sure I have a 3850 channel balance for my 29" x 33" Lawson Industries 7700 impact sliding window. I can't figure out what part I need from your catalog. Can you provide a proper model number to buy? There are 800 other homes in my community with the same windows. Your help is apprecia ... (cont.)

Distant between screws 2:1/4 W is 1:1/8 Length 3:5/16

I have screens in my windows that are held in by plastic clips. Do you sell anything like this? Or do I need a picture ?

Looking to replace rusted, broken bathroom window casement pivot arm operator. Picture shows: "Truth" on arm (see picture) What appears to be "W&M" on crank handle

Need 4 of these

Do you have replacement storm window/screen locks to replace CARE-FREE lock shown in photo? Thank you!

82-086 was bought. Need the latch that goes with this part

The wind blew robustly causing the window to fall out the wall. Somehow the locks were both open & this piece was broken. The windows are 19 years old when installed as new construction. I'm pretty sure that I cold called on Swisco some 20 years ago to inquire about your heattreating needs. ... (cont.)

Please see the attached picture taken by my customer. Unfortunately, I do not have any measurements to help locate a replacement. This is for a sliding window located in a condo complex. Is there any information you can provide on a possible replacement.

Hi. Please help. Adding pics for sliding door. Should I replace both? Thx!!!!!Jeremy

Hello, I am looking to replace the sash balance on one of my Milgard windows.. The metal portion is 21" long x 1/2" wide and marked 2040. Kind Regards,Mike

Please, let me know if you can identify this for me.Thanks,Bori

This lock Is broke at the curve of the piece that goes up in the wall. This patio door is 56 years old. Appears to be made out of pewter. Any help would be appreciated. Thank you. Jeanne

I need to replace the lock and closer on some old windows. Would you have these parts.Skip

numbers that I have found on the crank and arms are L30841, 02802, and 20810

Die cast cam is cracked. Holes on lever side are 1 5/8. Thank you, scott Need four locks please.

I measured them will need 40 pieces of those but also have some of the track is cracked and new springs is there a kit for these

Window hinge rusted through

I have an old storm door with no markings that are missing whatever holds the storm door glass in.I think it needs strips. Can you help me figure out what will work?Thanks,Mark