Viewing all customer Discussions for:

Other

Please help, if you can. I'm looking for one replacement Thomasville dresser pull. This dresser was purchased approximately 25 years ago. Thank you!

Andersen single hung Winddows do not stay, The diamater is 3/8 29 Lenth for four windows needs 8 spiral balance, and a window 3/8 diameter 13 Lenth I need 2 spiral baalance, as you can see and the picturo green color , not sure which serial number to order, please help me out.

Good Evening, A couple of my double-hung window panes fall down when unlocked (top pane) or don't stay up/open (bottom pane) and it appears that the pivot lock shoe is missing on some and damaged on others. Attached is one of the window's label as well as the part needed. Your assistance in identif ... (cont.)

I am looking for replacement part for drawer slider T31 220M400 bracket . Thanks Paul C.

I'm looking to replace these window cranks for some steel casement windows.

Hello, I am looking for assistance to identify the correct window balance replacement. My current window balance is 24"x 1/2". The stamp on the side is 23-4. Thank you for your assistance - Pat

Hello, Both of these wheels sit in the plastic fittings shown here and that sits in a receiving channel below. there doesn't appear to be any method of adjustment other than adding a plastic shim where the plastic fitting hits. The main issue appears to be that both these bearings are busted. May ... (cont.)

This is a window crank for an awning opener. It was installed in our cabin decades ago after having been salvaged from a still older structure. There are no manufacturer's marks on it. The holes along the long axis are separated vertically by 4 1/2" The lower holds are separated horizontally by 1 ... (cont.)

The coil balances are sprung

Hi - This is from an Andersen "Terratone" (I think that's the right name) sliding glass door from the mid-1980s. I'm pretty certain it's the original roller. 7163-2 is stamped in the top. (See Photo). ThanksJohnny

I have 34a, 34b and 34c. I also need the metal part.

Hi Please see attached parts need iding and pricing please 50 of each Thank you

There are no manufacturers labels or information. These windows are old and of an unknown age. Top is 2 inches in length by 7/8ths inch wide. The clip under the center is 1/2 inch.

I didn't see these on your website. Hoping you can identify them. The windows no longer stay open when these pop out of their location in the window jam/spring area.Thanks,Mike

Hi there, As shown in the first two pictures, I just need the part that goes on the window. Would you have the same part or compatible parts? Thanks, Jason.

Seems to be broken, like a spring missing, want to replace, how do I I identify what lock I need, and how do I get it out of door

the part does not have any markings or numbers on it .

Hello. I have a vinyl sliding door that needs a new lock and I was hoping you could provide me the part number so that I could order it from you. I saw one on your website that looked close but it had two slotted opening in the center where mine only has one with the other hole being empty. The d ... (cont.)

my balances are listed as BSI numbers are 2830, 2840, 28 B and 28 C they are 29 inches long. Which model would be best?

Greetings, Im having a very difficult time finding this particular Sash Balance here in my town. I figured you may shed some light and give me lead on this. The metal channel is 16" long x 9/16" deep. Spine of channel is 1/2" wide, but on the open side of channel its 5/8" wide from rolled edge to r ... (cont.)