Viewing all customer Discussions for:

Other

american national Standars door sn 311/312 SGDR 35 7180 1.1/2 WIDE

Interlock mechanism is broken

Window latch for tilt window. No name window. 11196 R is the number on the latch part. Dimensions : 2 3/8 inches long by 1 1/4 inch wide. Screw holes are 2 7/16 inches apart. I need the right latch but will take both in bone or white.

Dear Paul: My Float away bi-fold doors are still in working condition. However I have a hallway closet which is an issue every time we open. I need the entire bottom pin assembly on the side which slides through the channel.Thank youDave

Trying to figure out correct pivot bar & screw size. I think it's your 26-433 pivot bar? Not sure on the self tapping screw? It's 1/2" in length. Unsure of the thread size I need?

Channel Length is 27inchesChannel width is 1/2"Markings on the balancer are 26 5 LV CMC 7I need to find replacement channel balancer. Appreciate it if you can guide me in finding the correct replacement.Thanks,Anjesh

Please help. Thanks Want to make sure i get the correct size.

Hi all - I haven't ever done a window repair before. So I don't know how to measure how long a channel to purchase. It's a viking window with as shown in the picture. 29 inches of total length for the full window frame. I'm not sure the age of the window.

Looking for 8ea of the attached screen door rollers. Could be a brixwell 900-19216m

The part that locks the lower part of the window into the track has been broken... on both sides. The wind blew the window in, breaking the locks

Need replace broken pivot bar in photos. Window purchased at Menards about 10 years ago.

Hello. My wife and I recently bought a house built in 1957, which appears to have all original windows and window mechanisms. Some have cracked castings, and we are interested in replacing them. They look similar to the Getty models on your website, but the overall arm length is 13.5" vs the 9" l ... (cont.)

I purchased the Truth Folding Crank Handle, 11/32", for my Lincoln casement windows to replace some of the original cranks that had broken. Unfortunately, the inner diameter of the crank does no match the spindle on the window, so it does not grab the gear at all. I need a smaller diameter on that c ... (cont.)

I need two of the upper pins, caps and spring in the picture Two of the lower pivot brackets (I think that is the 21-200)Please let me know.William

Rusco US pat no 4185479 2

24 4 JL Caldwell printed on the metal my measurement of metal only 25 inchesWeight capacity (4) bottom plastic is one inch thicknessPop out clips on both sides for removable of balances on window.

Good morning, We have a Clawson Casement double unit with one bad crank or gear arm, there are no identifying markings or numbers on this unit, yet I do have the product # of the entire unit #CC2-2442. Looking for the assembly provided in my photos, one for the left and one for the right, sorry I co ... (cont.)

Hello, looking to confirm part required...thanks

What is the length (longwise) of the bumper? Or if you are not sure what I mean, what are the dimensions width, length, height? P.S. Does it come with screws?

Need replace parts for left and right casements- including new cranks and casing covers.Can you please advise as to what will work with my casement windows or any other information you needBestLisa