Viewing all customer Discussions for:

Other

This part holds the drawer slide for one of my kitchen drawers.

This is a drawer pull for a Lexington dresser purchased perhaps 20 years ago. The hole spacing is 3 inches, the screw length is 3/4 inch (thread only), and the screw diameter is between 1/8 and 5/32 inch, with a head diameter of 3/8 inch. The picture of the pull detached from the drawer makes it loo ... (cont.)

I need 3 sets of drawer slide hardware that matches the attached pictures. The diameter of the front roller is 1-1/4"; diameter of the center glide roller is 3/4"; length of the slide bar is 23-1/2". Please advise cost and availability. Thank you.

The four photos are of the two drawer sockets that need to be replaced. The photos show the view from the top front, the top rear, the front and the rear. Each of the two parts has "H-1041" printed (very faintly) on the rear of the socket.

Hello I am looking at replacing my worn top sliding closet door rollers. I currently have the Acme 4021 type rollers. From your website I believe that I have found a direct replacement, product code 23-027. Can you please confirm if this is correct? If so how much would it cost if I purchased 8 i ... (cont.)

The parts look like the 15-175 and the dimensions are the same also need dye cast cams if these are correct would need 6 shoes and 10 cams thank you

I am looking for a bypass roller hanging door bracket with a 3/4 inch roller and a one inch offset.

Porch screen Sliding door roller don't see any numbers, names marking found on this part. I need help to find a replacement part like this.

Hello. I am in need of a replacement lock switch for my dual-slide patio door lock. The part in question is, obviously, the piece I am holding in my hand. It is the actual lock switch. It simply snapped off after several years of use. All other parts of the lock system works fine. Is this part ... (cont.)

Kinco windows...see pics of spring balalnce

Please help find the replacement parts I need. Thank you

I'm looking for these plastic covers to cover the casement operator. They don't snap in, but have double backed tape to hold in place and come in right and left hand versions. The crank handle is a truth handle with us pat 361490 5560082 stamped in it. I've found the handle on your site but not ... (cont.)

I have a Simonton sliding door, approx 9 years old. In the handle's lock mechanism (need to take the handle off) there is a interior threaded washer that holds the locking lever in the handle. So if I unscrew the handle piece (two screws from inside) and the interior handle part comes loose, it ha ... (cont.)

how do these link together

I have 2 of the same doors, one has a handle on both sides but no handle with the locking mechanism, there appears to be the hardware in the door. (photo door 2) The other door the outside handle broke off but the lock works (photo door 1) If I can get replacement for the one with no locking mecha ... (cont.)

Truth entrygard 20755

What is this part called? Do I order the plastic with the pivot bar in it?

Window screw that goes into the bottom latch to slide the window up and down

We are looking to order 20 of these sprial window balances. There are no markings, names, or numbers. This building was constructed in the 1930's and to my knowledge may still contain the original windows. If you need any closer photos please let me know.

Please provide replacement part number with picture to replace tilt window latch shown in the attached photo. Thanks