Viewing all customer Discussions for:

Other

WINCORE SGD-R30 500 Series. I need, all or as many as possible, part numbers for this sliding glass door that was brand new in 1989. I cannot take the door off until I have the rollers or possible rollers due to a very ill patron. Most importantly I need to replace the top and bottom bolts, screws, ... (cont.)

I'm looking for tilt window locking terminal for Shelter window.L x W x D = 1 13/16 x 1 x 3/8Photo is attached.Thanks,Wayne

Looking for parts replacement for this particular model also will need new crank is well

The plastic bracket broke on wood Mark kitchen drawer. I need a replacement

A sash pin has broken on one of our double hung windows. The pics are attached of it. The windows were installed by a company (Homefix corporation) that I think is out of business. The windows were called "Energizer". Their main office was in College Park, Maryland. We just need a couple of pins. Th ... (cont.)

I ordered some parts from swisco recently and now I need a couple more but I'm having trouble finding what I'm looking for on your website. Parts I had ordered were 21-044 and 21-250 and 21-100.

I think I have found the replacement hardware for my glass mirror doors. Attached are a few pictures of the existing hardware. Part number 23-093 I checked the doors. All the rollers are missing. I did measure the track width. It was 3/4''. So I am thinking a 5/8'' wheel (roller) or less. ... (cont.)

I just received the sweep I ordered last week and it is not the correct one I ordered item number 40-207. The dimensions were correct 5/16 by 11/16 but this head is different than the one I received and when I received was not a double sweep

Hi I need a left pull set ( handles only )with total handle height of 8" and width is 1" The lock handle is inside. The inside pull is rounded but the outside pull is a straight handle. I hope the photo worked Thank you and I look forward to hearing from you

I would like to order two replacement roller mechanisms for our exterior Wooden framed sliding door as per attached photos.Matt

need balances

I have a 19 inch 5/8 " tube balance. I need the parts to go into the both of the window as well. They are white plastic and were broken. Scott

Can you identify this window crank? Crank is from a Silverline window. Marked inside with "patent no D-198202U Bottom holes 1-1/8" apart. Bottom hole to top hole 5-3/16"

This is a crank for a single lite WindowMaster window. I also need the plastic clip that goes on the crank and attaches to the window

Measurement, 13 inches, metal to metal Looking for 2. The spring says 12.5 I need two

This window balance is from a Window Master Window. Not sure which replacement to select. Could you help. Thanks Much

looking for what appear to be 2 separate parts for this window hinge

Seeking replacement tilt latch. Window stamped with JDI2008. Right latch has a R 3 and the left has a L 8. Demensions are almost exact to your product code 26-442, but not sure if that item will work. Need 12 latches, 6 right and 6 left. Thank you in advance for your insights.

double hung window foot fits into shoe of spiral balancer where do i buy ? spect us

This is the side spring to hold a single pane, double hung window in a C R Laurence metal back door with window, in place. The picture shows the broken spring. One end is broken off. The ends are bent to fit into slots on the window so you can push the window over to one side to get it out for cle ... (cont.)