Viewing all customer Discussions for:

Other

Hello, I have 2 PGT Windows. 34.25" wide x 31.5" tall each. I want to replace the balance springs - total 4 balances springs. Markings on the side are: 29 4 LU CMC 7. Can you tell me what product I need to purchase? Thank you, Marc

I need two rights and one left

I cant find this stop anywhere, not sure of the door brand. The homeowner stated is is an Anderson door.

Hi...Looking for sash cams..There were no marking, names or numbers I could find. Have attached photos of existing cam.Thank you for your helpJohn

The plastic cord that attached the sweep lock to the tilt pin is broken.

There were no markings I could find

Looking to replace this cracked handle. The screws are 4 inches apart. I'd rather a hardier handle than what's shown in the photo, which is largely thin plastic. The sliding door doesn't roll well, so a sturdy handle is necessary.

Need 2Thanks Clancy

I need 3 balances. The damaged one has "swisco" and "34B" stamped on it. The window is 72 inches high. The balance appears to me to be a series 795 (my guess), but with a cable and hook on the end instead of what is shown on the series 795 picture on your web site. The balance is mounted with a ... (cont.)

I have multiple locks that no longer lock or unlock on my Thermalguard windows.

I'm afraid My order may have the wrong end. 29" Series 380 Channel Balance. I am sending some photos of my track to confirm? (Order was cancelled).

Looking for the weather strip on the right of the picture of two side by side. I was sent by my boat manufacturer the one on the left with has a base of 1/4" which is too wide. I am looking for a pile with glide that has a height of about 7/16" and a width of I would estimate 5/32". I would be go ... (cont.)

Need about 8 of attached my attempts to obtain replacement s via your web site little success

Please help identify the parts I would need to replace for these rusted window cranks.

I need latches for 3 windows. The attached photos show the only markings on the windows.

looking for crestline glazing bead that is close to this profile. window is from the early 80's Daylite size is 18 1/2 x 66 1/4. Unit thickness is 7/8

Need all the hardware that holds the windows up. .550 diameter with the blue tip

The corner on the left is the original. The corner on the right is your 95-270 On mine, the main male part is 1/8" thick. Your male part is 3/16" thick.Both secondary male parts are the same at 1/16".My corners are labeled 783 or 782.Your corner is labeled 784.Do you have a corner that is 1/8" mai ... (cont.)

Looking for Pennsylvania House furniture drawer stops for above named furniture. Photo attached. Please advise what part will work as a replacement.

Need to replace this part on 2 windows.