Viewing all customer Discussions for:

Other

need to replace some broken vent latches on some older Certainteed vinyl windows they seem to be about 2 or 2 1/2" by about 3/8" wide in a rectangular shape Do you have anything that could replace these in white

Hello, I need to replace a few parts across two of the same windows. First, the top latch came off and now my window will not lock. The second parts are for the right and left side of the window that keeps the window up (and there's a latch to lock to the side). Do you happen to carry these parts? ... (cont.)

NEED TO KNOW WHAT BRAND & COST OF REPLACEMENT HINGES

These simple little rectangles have slits in them so that they'll lock in to the beginning of the drawer track. This changes the position of the drawer, enabling the drawer and doors below to not scrape on each other. It also makes the drawer glide smoother.

I need a replacement part for the above image. please advise or direct me to a source.

Hi, i was wondering if you can provide a replacement for this part. I have Simonton windows probably from between 2000-2005. I have one window with both clips broken and one or two more with one clip broken. i assume these can be popped out somehow and replaced?

The attached photo is from a Marvin Integrity window aprox. 17 years old. I assume there is a replacement out there somewhere! Hopefully this pic is good enough for you to see what I need. Thanks so much! Joni Hansen

I am looking for the replacement shoe or the hinge are for a HURD window with TRUTH hardware produced in the 1998 - 1999 time frame.

looking to replace these. Will need 6 to eight of these. Believe to be series 795, but concerned of beveled portion near bottom maybe not 795.

Need two of each of these products today.

Retainers fit emco storm door. Holds the mullion to the door 10 retainers in all. Thank you for your assistance Bob

This is a tilt Latch from a window installed new in 1999. Window brand is patriot. Size as I measure from the top is 5/8 by 2 5/8. This is the measurement of the rectangle not including that little tab underneath that just out. I do not know the depth. What is the replacement part that I need to or ... (cont.)

G'day Could I get component part description and part #'s and prices + winder Thank you

Metal clip is 1 1/16" long tip to tip and 5/8" wide from tip to tip. metal clip is threaded 8-23. the spring is 7/16" long by 3/16" id. nut on top is threaded 8-32 and knurled.

The right side channel is broken from the bottom but I cannot figure out the part number to order from the inscriptions. Thanks so much.

Looking for replacement jambliners any help would be greatly appreciated. Thanks Sean

Need to know which balances needed.

What will replace this storm door handle set? Inside and out.

looking for inside latch only

This latch is is good working order, so I do not wish to replace it. However, I am missing the striker place. I haven't found a model number on the latch nor on the door itself. If possible, I would like to purchase a strike plate that will work with this latch. Thank you, T. L. Schwab ... (cont.)