Viewing all customer Discussions for:

Other

Looks like the stamp is 10J, which is not listed for this design, please advise. Thank you

Hi Part Expert,I would like to purchase this part from a Graham window and have not had any luck trying to email or phone Graham Windows.Can you please help me find this part.The sash guide that I am looking for is 1 1/2 inches wide,2 3/16 inches long and has two sets of three holes in it.Larry ... (cont.)

Hi. Looking for a replacement latch for a metal casement window from the 50's/60's. Thanks for your help.

Please identify the size I need and tell me what I nee

I have a Monarch mirror bifold closet doors and they are old...1997 is when I built my house. The door snuggers broke and I was wondering if there is replacements for them. I have attached photos of the good ones from another room. Any help you can give me is very much appreciated. ... (cont.)

This is located on the sash of the window. It hooks into another part and it makes the window go up and down.

It is a latch on a Certainteed window that keeps the window from swinging down for cleaning. The one on the right side is fine; the one on the left is missing, but you can see the 2 holes where its tabs will be inserted.

I need to find this pin

Hello! We are in search of 2 sets of replacement drawer track and guides. The existing guide has the following marking: "Ronthor Pat. # 3185530" Any help recommending a suitable replacement would be greatly appreciated.

I have a garage window that has disconnected hinges with broken or missing parts and I would truly appreciate any help locating new ones, Thanks, Matt

This is a balance from a vinyl window. I have never seen one like this and need to repair it for my customer.

no markings or brand on any windows-house is in Naugatuck,Ct.

Marvin is the only lettering I see on the crank. I also need the arm linkage that allows the window to crank in & out

2 part clip consisting of an aluminum frame (1.24 x 0.75) with a sliding plastic piece used to lock interior storm windows into small holes in the window frame.

This is for a double hung tilt out locking window. Can't find a part number anywhere

Hi,Need 8 of these for 4 windows. House is a Del Webb in Sun City Arizona, built in 1975. Couldn't find a match from your 1/2" wide channel balances. The windows are non-tilt vertical double-hung with aluminum frame, dual pane. Dimensions approximately 71" by 23". The guide stop tab for the scr ... (cont.)

I am trying to identify this window balance, I have searched for a manufacturers name to no avail, it is not on the window lock or stamped anywhere. Do you have any idea who might be the manufacturer of these windows. Morgan

part no.2740 27 inch balancers need 2 # thanks Steve

The string and one small part on the end was broken one day, and i think need to replace the whole part. could you find this? what's the cost of the part and the shipment to San Jose, CA. thx!

Looking for replacement parts- complete lifters to fit my 2130 Z (off Salt Lake City, UT AMSCO Windows) and Top Sash Guides (closest fit to 18-052 product). Would like your recommendations.