Viewing all customer Discussions for:

Other

Hello, Can you help me please find these parts?

I have several Roto casement operators (left and right about 5" as shown) that do not work. Do you have this style and is it possible just to replace the crank or does the whole operator have to be replaced?

do you have this

I need to replace both of these parts in my windows. Can you please give me your part numbers for the replacement and refer old and new together so that I can order for multiple windows. Thank you. Darla

Needing white jamb liners for Coradco wood double hung windows, flange style

I have double hung tilt window with a broken spring. I don't know if I need new 3D335 picture number part? I would like two spring replacements so they ware the same. Also don't have a tool to load them. Want to make sure I'm getting the right parts. Also broke the plastic piece that goes over th ... (cont.)

I would like to find a replacement for one. One of the photos shows a number that reads N19 l 22 KBC2.

I hope the pictures helps. Markings 27-4 BSI OC. from looking at other posts this may be a custom order as it might be an extended travel balance. I may need 4 total as I have two windows out of commission and both use these extended travel balance. Please let me know if you need additional pictur ... (cont.)

I need the two bottom side brackets that fits into the jamb Window frame that attaches to the sides of the window springs

1. Drawer size 34x18x7.5". Please note, the drawer recesses in, so there is not much room on either side for the slides. 2. The actual dimensions of the slide are presented in the pictures. 3. I believe it is part #32-223, but would prefer a 16" track. Thank you in advance for your help. Monty ... (cont.)

Balance is 1/2" wide. Metal part of balance is 27" long. If including plastic boots, the entire balance is 28" long. The bottom boot has #15P102 and a 3 below that number. The other balance's bottom boot has the same part number but a 4 below it instead. I can't seem to find any part numbers for the ... (cont.)

I am trying to find the replacement part for a window pictured here. The letters and numbers read 21 B B.S.I. Any assistance you could give would be greatly appreciated. If you have this replacement part, please include what the price would be. Thanks you, Susan

I think these are the 390 part numbers as the shoe is 1 1/8" deep. The channel width is 1/2". The length of the metal is 31 5/8" though, not 31" or 32". Sash weight is 16.5 lb. There is a marking of "31 3 pm" and "BSI" on the back of the channel

I am looking for replacement parts for my window

The part is located on top /side of the window frame. Non tilt window. ? " wide by 1 ¼ " long.

i need a lock latch for a Jeld-Wen v2500 contractors patio door.

Need new crank assembly and mounting hardware.Found decal with series 7700, C-R50-32×60

These are old doors (house built in 1993) and I need the rubber that fits into slot to be 3/8 inch wide. I tried one that just dropped out. I think it was a quarter inch and was too small. I have four sliding screen doors and need your help. Thanks, Hilary

These are the rollers for an Anderson sliding screen door. I need all 4.

Tilt window replacement latch needed. Searched webpage and cannot find compatible latch. Please advise.