Viewing all customer Discussions for:

Other

These are all the pictures I have

It is 2.5" long and appears to be approximately a #6 in diameter. The threads are more course than a normal machine screw

Has number 1132 imprint

Hey Guys , Will you be able to help me with the following part ? This is a Anderson patio glass door and im looking to replace 4 roller . Thank you Benny

I need a balance and latch for my windows. I've taken pictures of one window that is the same with working parts. Can you please tell me what parts I should order?

Non title window. Length 14 inches. Width 1/2 inch Number imprinted 1320 Please advise which one will I need please.

Need to replace these and having a hard time finding right match

Looking for upper hinge assembly. Swing arm is 5-1/2" long, bracket on top of window is 7-1/2" long and frame piece is 10" long.. Window swings from the left side looking out.Thank youMike

I am looking to replace the pivot shoes on a couple of my windows which have cracked and no longer hold the spiral balance pins. The dimensions of my current pivot shoe is as follows: Thickness: 1/2 in Height: 2 in Width: 1 1/4 in The only marks on the shoe is the number 21. The current sh ... (cont.)

Can't determine which is the correct replacement part. The feet at the bottom of the channel balance have broken off. The channel is 1/2" wide and 27" long. I've attached close-ups of the top and bottom of the part. Thanks for your help. Bruce

No markings. Can you supply a replacement?

Looking to replace both crank window hardware. The gears are worn down, so you are not able to shut the window. The brand is Truth. They are seventeen year old. The window is one large pane with two separate windows that open from the sides.

Back support for center T cabinet drawer Raygold Mission oak kitchen cabinets

I'm looking for the little triangular relief vent covers, about 1.5" long, that pop into the pressure relief hole drilled on the outside of some window frames to equalize pressure.

Hello,My customer writes, I need a shower door handle with the handle hole spacing 2" apart center to center and then the length horizontally from center to center of handle mounting holes is 28". Pictures attached.Please advise if you have this part available; please provide the cost and lead time. ... (cont.)

I'm looking for the vertical sweep for an older wood Pella sliding screen door.

Please let me know wick dual arm operator will fit those windows/be identical to original K K parts.

Is broken. Handle fell off etc number on door 14608031 111161115

I need to acquire the bottom white piece and if correct there is a round piece that the upper left metal piece slides into for window rotation. Will need both. Also need part 15-185 Spring Cover Wide. There is no issues with the Coil Balance. Windows purchased in 2005 from Norandex/Renolds Distr ... (cont.)

I need some window tilt latches for windows that are approx. 35 years old. The company is out of business. See attached pictures.