Viewing all customer Discussions for:

Other

Looking to replace a 80x48 patio screen sliding door In black aluminum frameWhat would be the cost?Thank you,Shelley

I've attached three images of a window crank I need to replace (ridges inside have worn down). No identification markings on the handle itself or the window. Overall length of the handle is 3", and hole that attaches to the window is 3/8". Thanks!

I've attached images of a cross section of the existing retainer strip and of the door's identification information. Please let me know if you need anything else. Thanks!

I need a drawer bail pull for lexington chest. The pull has these numbers on the back kbc1 k5947 and it is antique brass. I only need the swing pull part. Thank, Vickie

I sent a message earlier. Here is a picture of the part I?m looking for. It was from an Anderson window. Looks like71508-3 written on the back. Do you have any of these?

need picot shoe lock and picot arm

LOOKONG FOR BOTTOM RAIL FOR DOOR PORTION MEASUURES 27 1/2" LONG WITH GROOVE FOR VINLY SWEEP CHROME FINISH THSI IS NOT BOTTOM THRESH HOLD RAIL, ITS ACTUALLY BOOTOM RAIL THAT SLIPS OVER DOOR GREY GASKET

Looking for direct replacement part. If not available, willing to substitute for different roller such as item 81-151. Most important is width of wheel is close to 3/8 inch. Wood track groove is 1/2 wide. Rollers should support approx 200 lbs per pair. Thank you. Chris

can you help me?

What parts are needed to keep my window up? We have Philips CCMC#12743-L. I also need the correct left and right latches. Thank you

I am in need of one window balance for the model number attched in the photos. Please advise of availibility and price at your xonvenience. Thank you for your help.

I am trying to idenitfy which part to order, maybe a spring??...can u tell which spring to order, or how do I adjust the spring so the door would come up a little, it is rubbing at the bottom

Looking for window screen latch clips that match with the one in the photo.

Left side of the window opens out. Crank handle is broken

No name on roller assembler or on the screen it is mounted on. There is a label on the screen handle shown in pic 3348; it has BX-441 in the lower right corner of the label. The die-casting of each roller has L or R stamped on it for left/right side of the screen. Two rollers go on the top of the s ... (cont.)

I need screws for this. What is the rod called?

Hey Guys, Looking for a replacement part for a Milgard series 5621 SGD-C20/SGD-C25. The throw for the latch broke as well as the screw holding the square rod in place. Can you help? Thanks Mike

How wide (thick) are the wheels on the 75-019 tool?

Hi, It appears to be that the window balances are still in good working order. However, they do not stay down because the little plastic pieces that attaches to the top of the window that keeps the balance held down is broken. Is it possible to just purchase the plastic retainer piece that keeps t ... (cont.)

I have a brown automatic door closer. I just want to replace the bar. It is showing signs of wear. KB