Viewing all customer Discussions for:

Other

I need to replace this type of window latch. Would you have what I am looking for? Thank you for you help, Mary

New house. Door handle is loose. Took apart and found the piece where the handle goes through to turn the latch is worn out. Door locks by pulling up lever and three latches pop out to lock, one on top one on bottom and one in middle. No clue what this hardware is called or how to go about buying a ... (cont.)

Hi, It seems that the plastic pieces holding my windows that are 30+ years old are all breaking. I have taken out the channels balances out and they seem OK, but on windows having issue its all the plastic that is broken. Based on the pics, I have provided, is it possible to just get the plastic ... (cont.)

We are trying to fix our window and discovered this part is broken, what is this part called?

I need to replace this broken window latch.

Hi Swisco,The left-hand tilt latch on one of out Alside vinyl replacement windows has broken and i am looking for a replacement. The tab that holds the window latched has snapped off. I am not sure how these latches can be removed and replaced, either?Do you offer a replacement? I have attached a ph ... (cont.)

See attached picture. We need a replacement part please. Thank you.

Circa 1950 jalousie window operator says 40-830 inside - gears worn out

25 4 IW CMC 11

Are there any replacements for these type of broken seals? Multiple size and number of windows need replacement of these seals or weather prof strips. Thanks.

I had ordered the 2950 version and used them on wider/heavier windows. Attempted to use these on 25 lbs windows and they keep moving past the window back to the stop clip. I am assuming the spring is just too strong for the lighter windows. However there is a slight groove in the frame that one side ... (cont.)

Can you identify this part number for me?

Says 20 X ....these are caradco double hung tilt out window from 1982. What replacement channel do I need? Any advise on removing them? I need about 12 of them. Brian

Looking for an inside latch for a storm door with a 5/16" spindle. Something similar to part 40-150. Can't get the old spindle removed from the original set so need a spindle too.

Drawer guide plastic components

Hi, we are looking for replacement hole plugs for our reliabilt door with window grid on top half. Do you carry or can you direct us as to where to purchase? Thank you!

Hello, I need to replace a shower door handle pull. Part number reads L121-1A . Oil robbed bronze.

Replacing broken Pella lock. Part #14F00001. Do you sell replacements? Thank you

hi i qm looking for q replacement runner for my kitchen drawer. It has Unigrass 6000 printed on the side. I am based in Australia

Hello I need help identifying which replacement part I need to order. The metal part is 1/2 inch wide.almost 5/8 inches deep and 26 11/16 in length. It didn't match any of the pictures I saw on you parts. The plastic pulley is at the end f the device not inside. Thanks, Grant