Viewing all customer Discussions for:

Other

The window will not stay opened. The footing on the window are worn.

Installed in 1983. Looking for replacement pivot lock shoe. tilt In

Hold not find any ID numbers etc.

Need To replace this part

Need spiral balances as in picture

So I thought it would be wise to remove the cross bar design around our windows in the front of the house. They had dirt and mold pushing against the window. I removed them thinking our back windows dont have those. What I found out is I removed those and at the same time I removed the glazing bead ... (cont.)

Would that I had any names, numbers or markings. House built in 1998.Latch is approximately 2 1/4" long and 1/2" wide. Beige color made of plastic, a little give to it. We have gone to Lowe's, yet to hit Home Depot or Ace Hardware and scoured the internet to no avail. There are five window screens i ... (cont.)

I have this retainer strip that I would like to replace. I have no idea as to the make of the storm door. I saw this post dated November 29, 2016 and believe it to be the same as I have. At that time you recommended going to storm clip 70-180. The problem is the offset from the door to the windo ... (cont.)

Need a full replacement of window balance on a home, slides up and down. Old and rusted part assembled in a home built in 1995. Nylon rope for curtains is broken and needs a full replacement.

Do you have what I need ?

This is a U.S.A truth part. I don't have the part number end of the broken handle lock. However it does say USA Truth and the word lock near the sliding lock button.I need to get 1 like this for my client.Regards Ed

Hello, I am hoping you can help me. I have a set of window balances that need to be replaced at a customer residence. They are stamped 26S (BSI), and I cannot find them listed as reference on your page. The sash weighed in at 30lbs . I am hoping you can help. Oh, and the metal chanel measures in ... (cont.)

Just bought the house and this one window latch doesn't line up. It's about an eighth of an inch high or low however you want to say it. So when you spend the cam around to lock it it doesn't quite wrap all the way around from the bottom around to the top the locking tab on the fixed panel. I'm hopi ... (cont.)

Hi, please find the photos I have attached. The rollers are a bit unusual as they ride the tracks on the outer two sides of the rollers, not the center of the rollers. Strange design. However, it appears you sell some that are very close in appearance. Please help me find the replacement parts. Rol ... (cont.)

I'm new to the spiral balancer game, but the parts you sent me worked perfectly. Now, help me find this piece. Is it called a shoe?

Looking for these parts

It has a plastic top and looks like an over grown thumb tack.

Hello, Please see attached photos. I am looking for a window channel balance. The model name is BSI 17-3. Its dimension is 17 3/4" by 1/2" (metal potion). I am looking for two of them. Do you happen to carry this, or if not, know where I can find one? Seems like I'm having a hard time based ... (cont.)

Hi, These pivot bars are spring loaded and die cast. Do you have them? 1980's aluminum single hung. Thanks Ernie

28 C stamped on existing balance and is 28" long