Viewing all customer Discussions for:

Other

Hi, I could not find the brand of window on my 20 years old house. These lock levers keep breaking as these are made of plastic. I am looking to replace these with stronger metal levers.

Hello, We have a 1968 sliding mirror and would like to identify and buy replacement rollers for it. The mirror itself is two panels, each 30"W x 36"H. The rollers, two per panel, are approx. 3/4"L x 1/4"W x 9/16"H (see pictures). The roller assemblies are just pressed into the bottom of the mirro ... (cont.)

Please help- I have several windows which won't open and I am trying to determine the correct replacement balance. I know it is 28 inches, type A, non tilt but I can't determine what type based upon the ends.

Looking for the correct plastic parts on the ends

I need a few of these. It's like a guide for the screen. Thanks

There is a "v" stamped into the side of the lock With the cam being broken can't tell if it is 45 degrees or vertical Thanks for your help

hello i am having touble identifying a new casement closer i need. please see the marking below i can find main arm says: entry gard 40754 secondary arm says: 20810a other secondary arm says: 30744b channdel that attaches to window is about 11-3/8" long

Used to shut the window and latch it. Where can I find this part?

Need a replacement piece for this awning window.

I have a pair of Stanley mirror sliding closet doors. One door is missing hardware ( just bought house) and I am looking to repair. This is the part for the other dood that works

These double hung windows installed on 1999 are of an unknown manufacturer. They have fixed upper sash and two balancers per window. The windows are made of PVC and do not use screws to attach parts.

The hinges have a design on them, presumably from the manufacturer, which hopefully shows up in the photo. Under that is "USA" and the number 23. Two screws secure the hinges to the doors and one screw goes into the cabinet. These hinges are 20+ years old so I don't know if you can find an exact r ... (cont.)

I have attached the pictures above.

The upper metal hook doe snot move and will not allow do to lock

OP05-7810 is the number on the inside of the handle.

I am having a hard time figuring out which channel balance is needed. The rope snapped and it says 26 4 LR CALDWELL on it but the metal is 27". I don't know what it means to measure the 'sash'to get the weight or whatever. Can someone please point me in the right direction?

Email me please

Do you have this part and if so what is the part number?

Part has e 2730 stamped on it.

I'm not sure if the part is called a balance or a slide.