Viewing all customer Discussions for:

Other

Windows were purchased from Chase Pitkin in the Rochester, NY, USA area, about 15-18 years ago. Thank you very much for your help!

Looking for replacement sach stops for older mastic double hung windows

Good evening: I am trying to find replacement c-clips for some screens. Do you carry these? Thanks, Charlie

Please let me know if you carry these!

Good morning, I was hoping you could help me identify the part shown in the attached image. I am only looking for the left-most part that is being directly pointed at. Thank you for the help.

The window is a 30x36 about 8 lbs. no marking on hardware. Windows 20 yrs old "Certainteed" brand. 3/4 in wide spring with short tongue.

Hello, Need to replace channel balances for windows with a 1/2" width and length of 14". Unsure of what series to order. It's looks to resemble an S385 but still not confident. Additionally, not too sure on what stamp option to get. Looking for expert advice. I've attached some photos for reference. ... (cont.)

Hi I need to have a 1/2" x 31 7/8" window balancer. Which part should I get? thanks

I ordered #23-164 bi-fold door snugger and it does not fix. I need a snugger that fits a 1-inch tract. Picture attachedGarry

Hello I have the PPG Herculite sliding glass door that I need to replace the handle and the lock system. 16CFR1201 CII ANSI Z97-1 1984 5/32U SGCC-675 620701 do you have it in stock and if so what is the price

Hi, I'm looking for the correct part number to replace this balance. D27 8#31 11 84 Also there's a number 11600-17 Thanks

Hi- I have attached photos of a window balancer from a window in a condo located in Florida. The building was built in 1984. I am looking for new balances. One of the photos includes a stamped number on the channel. Jim

I need your help identifying these parts to ensure I order the right parts . There is no spring strength marked. The weight of the sash is 14 lbs

I have 8 windows that have corroded pivot bars. The part disintegrated in many of the windows. Here are pictures of one type of pivot bar that is still intact. In live at the beach, and this picture of the pivot bars look like a hard type of aluminum. How to figure out the right type of replacem ... (cont.)

The code for this is 28 4 K0 CALDWELL I need to change the piese

The balances on both sides of the window were cracked off. The plastic tabs at each end were broken and could not find the pieces so am not sure if they had wings on the bottom or not. The length is 19" long. I will need to order replacements for both sides.

Trying to replace. Cannot find locally

Brackets are located between draw slates and with out 6600 old rear supports I would have to take cabinets apart. The slide on the back would make it easy to replace. Your friend, hard to reach....

Will this tool work on flat spline? If not, do you carry one that will work on flat spline?

See attached photos to identify the missing lock and please advise if we need to change the whole piece.