Viewing all customer Discussions for:

Other

I am not completely sure, but it looks like your part 15-195

These hinges needs replaced and are located on the bathroom vanity doors (2) and all kitchen cabinets. (24) If you have the replacement is there a discount for bulk purchases?Thank you,Kevin

Where do you get the plastic bracket that holds the opening rod from the operator in place. It is held in by two screws, approximately 1.5 x1.5 inches and has an approximately 3/4 inch collar centered in the bracket.

Note the short section about 2 1/2 inches or so and the longer section of the arm that has a clip on the end. This is about 8 inches. Anything close to that? Manufactured around 2005 Andersen. Thanks

Hi, I have a vintage mortise lock or Marks with a stripped cylinder set screw. It's brass and approximately 2" in length x 3/8". I believe it could be a 91A. I'm in Louisville, KY and having a difficult time locating this. I searched Habitat as they sometimes have mortise locks and supplies. Thank ... (cont.)

I need 2 of these window pivot pins. I cant find a brand anywhere on the windows to help narrow down a pin. Hopefully you can help even if I have to modify it slightly. Thank you Mark W

Because the side of my housing say 10, I should chose a 10 pound spring right? But the series 160 is 1/2 in and my stock spring is 1/4 in.

I need new weatherstripping for m Stanley entry door. Your part# 58-008 look to be correct but my door width is 42 inches. Can you help Thanks Dave

Here are some photos of the mirror roller door, with an undamaged unit, + the incorrect one received yesterday, as per my other email, stamped on the correct part is "Stanley 17-4116", which I assume is the part number for Stanley- Monarch (spelling??) ? Harry

Please call me

I need 4 wheels and tracks

do you carry this weel

The screen handle parts are broken and i only have this piece. front and back photos attached. The dimentions are on the last photo. Can you help me indentify which part I need to order to replace mine. please?Teresa Wooldridge thank you so much!!!!

I have Milgard tilt in windows in my condo, which was built in 2009. I just had a balancer shoe break. I believe the correct replacement part is 15-195. The locking shoes (that hold the windows from sliding when tilted in) look different from mine to yours. Dimensions match (1 1/4 wide, 1 7/8 hi ... (cont.)

Hi Guys, do you recognize this operator? Window did not have a name. Don't have any dimensions. Hopefully the unusual shape cover gives you a clue. Appreciate any help.

The top that hooks to the spring is broken off and missing.

I need a sting balancer for my window. I attached a picture of the label on the window. Would you be able to tell what part I need?

Hello, please quote for the following: Balance - Stamped 28C 795 Series Channel Balance With 15-198 hook Qty=2 Thank You Sal

This product is made by Adams rite manufacturing co.

5/16 on clip side 3/4'' on face side