Viewing all customer Discussions for:

Other

We have wood framed sliding glass patio doors installed my an independent manufacturer (Pullum) in Michigan many years ago. One stationary door section and one sliding. The weather stripping where the two doors meet vertically in the middle has brush stripping that insets into plastic channel piece ... (cont.)

Need to replace existing door handle & lock, mechanism won't function (lock/unlock). Finish worn, Lock set in photos is 25-30years old based on best guess. Could it be the 82-400 series or compatible with it? I measured 1 3/8 wide. 8 1/4 long on plate.

I need to replace 4 of these cranks outs. From a mid 80s Anderson split windows. I have two windows that would need both a left and right The long piece is approx 12? Any help is appreciated

Sliding glass porch door

This is stamped 2730Z. Is the 15-002 shoe that is 1? deep, measured as shown in my last picture?

I am looking for a plastic/nylon replacement for an early 60's Pella awning window. The diameter is 3/4" and the "track" slider is 3/16" tall. The overall length is 1-1/4". The thread on the shaft is about 3/8" diameter. I need a Quantity of Five.

The metal piece is 3" long 1/4" wide. The groove inside is 1/8" wide. The metal piece fits in the white plastic, which was at the bottom of the window. The window does pivot out to clean. The part I am showing broke and the window cannot stay open. There were no markings, numbers or anything else th ... (cont.)

This is a Marshall sliding window lock

I have several windows having broken latches to release the windows for cleaning. Where can I find the same kind or can be used to replace the broken ones?

Replacing my weatherstripping on my 36 inch front door. Both sides and top. What is the right product to use? The local hardware store has the slide in grove for the stripping on the wrong side. Doors are from 1984. Oringinal was magnetic on the top and one side. Compression on the hing side. ... (cont.)

Hello, I need to change the sliding door rollers, are you still sell them? Can you send them to Mexico? I need 100 pieces.

The latch has the number 102 stamped on the back side of it. Can you please try and identify this part. Thanks

Simonton windows, coil info: 5232208, # 4.0, 35" P

Please see picture. Is there a part(s) that can replace this? I'm looking for quantity 6.

Part for an old jealousy/awning window

Discussion number D56963 , How do I find the part for the attached shower door rollers, King ANSIZ971-1984. Do I actually need to drill into my glass? I don't know why, but the installation guide, step 8 says drill a new hole. And that new hole is 7/8" away. (7/8" away from what?) ... (cont.)

Looking for replacement hinges USIP Hinges. The measurements are 1-1/2 to 1-9/16 from the center of hole on the hanger part to the center of the furthest hole for the door side. Sorry I don't have any photos

what I can see is : u 8 28c or u B 28c the channel is 29 inch length 9/16 width (1/2 inch).I don't know what the different options you have in your website.Please,help me find the correct one.Thanks!! JUAN Torres

Part is broken. It has a spring on the inside that holds a piece in the channel

The part holds one end of a slide assembly for a kitchen drawer. On its back: "U.S. PAT. NO. 3,090,662" Beneath that: "PATENTED 1965 CAN." Beneath that is the single digit "6".