Viewing all customer Discussions for:

Other

I need the part number for the channel balances I just removed. The numbers on the balances are 34 4 IS Caldwell. The sides are hemmed. I've attached several photo's.

above door latch

I need 5 cranks bronze, clay or dark bronze will do Thanks

Looking for a few sets of mobile home window tilt latches. 3 1/2" base length, 7/8" wide, 2 1/2" bolt hole width. For Warnock Hersey double hung windows. Thank you so much. Scott

Hello, The wheels on our sliding glass doors need to be replaced. They are getting increasingly more difficult to slide open. The only sticker i've been able to find on any 4 of our doors is the one I attached. Thank you, Stephanie

Looking for Anderson balances with markings BD18 725 10-8 and 11600-17

Please review and advise.

dear sirs, I am looking for this window spring balancer fully. it is the one that attaches to the spring inside the ribbed channel

Hello, this came out of a double hung anderson window installed approximately 1985. We'd like to replace all window balances in the house. Can you identify this part and provide me a part number and price? Thanks, Dave

We have AAMA/ANSI 101-85 600/650 series Windows. We need new lock hardware for three of them. The stationary part is 11/16 or 3/4 ? long from outside to outside and the Pivot Part is an 1 1/2 from outside to outside. Do you have anything this small?

I have balances that just say 26 4 GK Caldwell. They measure 28" from the end of the plastic ends. Thank you.

Could you help me find the right balance for Milgard window. The numbers on the current one says 24-4-10 - I want to replace both of them just in case. One of them seems to have come loose and falls down when you open the window. Then the window is off center and is hard to close. ... (cont.)

Good day.....I am looking to purchase the complete bottom roller assembly for a GAPCO sliding patio door.....36"x80"...Code 50-3....."HP" Series.....Type & Class SGD-B1-HP.....Series 1055.....the complete bottom roller assembly has 4 metal rollers retained by 1/4" Spring pins.....the wheels appear t ... (cont.)

My spiral balances are 22 inches long and 9/16 inches wide with a blue end tip. I already ordered the charging tool from Swisco. What are the replacements for these spiral balances? Thanks Gabr

I am looking for a channel balance I have never seen before. The channel is in the frame of the window not the window sash. the balance is a modified block and tackle style with a tube running down the center of the tension spring. The windows are 10 to 12 years old.

Came from top of stash or balance? Thank you Steve.

J81 5#23 3-82 11600-2

Replacement parts needed for mirror door bottom roller for steel frame door. May be 23-028 as seen posted by Tom from SWISCO by way of photo posted April 2, 2018, please confirm.

This is from a @45 s 35 non tilt double pain window. The metal channel measures 31 7/8" and is 1/2" inch wide. There are faded markings and the best I can read of them is "315" and I believe it to read Caldwell. I need two for this window, I believe the window to weigh 25-30 pounds or so. Th ... (cont.)

Please let me know if you can get me 2 replacement wheels my email is kaymcg1 @ Verizon. Net