Viewing all customer Discussions for:

Other

I need to replace the window trim pieces. Wondering if you have the parts for this windows

Hello guys, I

Please advice

Hi, Could you please indentify the 4000H window shoe in the attached picture and provide me with the part number for me to order? Thanks, Emmanuel

The channel balance has broke off the above cap. Can you advise? There are no marking on the window or channel.

nylon plastic lock for awing windows Lft. and RT. used as lock down when window is closed plastic part gets uv damage and falls apart after time part might be sold with 6" alum flat bar. please email any info on part and cost Thank you Jim A

Cannot find part on site

Hello, We are looking for these table leg cap protectors. They are about 2 1/2" length X 2 1/2" wide X 2 1/2" tall. black hard plastic. Thank you in advance for your attention and effort.

D/M 3137026 A/S 30S7401 (see attached photo)

I need to replace the bottom part of a Patriot window that recently cracked.

have a Traco Tilt Latch that measures about 5/8" x 2.5". Can u pls suggest a replacement?

Looking to replace old worn out window coil balances. Our windows were installed in a new house in 2003. The manufacturer of the windows was MWWindows who were later purchased by PLYGEM in 2004. The coil itself is stamped with the number 7 on it. Several of the windows had a serial number ... (cont.)

Can't find these and I need to replace them.. Help? Thanks!

I HAVE WINDOW PART NUMBER IS (NAMI A-151-1-51) SERIES NO 3722/3732 HS-R25 I DONT HAVE PITCHOER OF THIS CAN YOU HEALP ON THIS PARTS

your equilivent to a 30310 balance.

I have the Door Flush mounted Key-Holed old "DNS 16 Flush Mounted, Pull Handle", Question Will the 28-00k replacement version work also can I pay for this item using a visa pre paid debit card...

Can you look at my sliding patio door wheel and tell me if this is yours Please see attachment Please make sure the wheel fits over your stainless steel track repair that will be ordered with it. The track I will be putting the repair cover on is .1874 or 3/16" wide which will be the inside dime ... (cont.)

You solved my top roller problem. Many thanks!! Now I should order a few bottom rollers, in case I need them. See photo, for your recommendation

I am looking for a counter balance for a MI window that tilts in. As you can see in one of the photos it has a marking of 35C tBSI. It is the 450/650/850 aluminum series

NO MARKING FOUND