Viewing all customer Discussions for:

Other

I am trying to find replacement window cranks for alcan awning windows. windows are 27 years old

Hello, Can you please help me with ordering replacement parts. I have two casement that have bad hardware. mounting plate. #4241541, gear#30471, and arm# 30636, and 30637 Thanks in advance.

I have andersen narroline double hung windows and need a seasl for the lower sash. the groove is 3/8" wide

I need help to get the right channel for a non tilt sliding window the length is 32 inches and width is 1/2 inches thanks Jalal

Good morning. I need ball bearing side mount slides, 16' or 18', full extension, soft close and 3,5cm tall. I can't find 3,5cm tall, just 4,5cm. Do you have this product? I need 500 sets.

hi! I would like to identify which replacement part I need to buy. There is a roller that is broken - please see pictures.

I need the insulation strip that goes into the channel around each section of the window. It is a narrow strip that is pressed into channel. Thanks

Where can I purchase a charging tool for sash style tilt windows?

Hi can you supply 2 Millguard sash balances. See photos. Part number 15-5 II5 CMC 50

I have Acorn tilt out up and down slide on the lower portion only. I believe that I need a new balance tube and a new spring. However my spring is wound not spiral. When the top part of the tube with the tab cutout broke the spring twisted. I was able to close the window but the spring still ha ... (cont.)

Hi folks, I have a single-hung Milgard window that needs a 40-pound balancer per the attached image. I'm also in need of two pairs of those 2" U-shaped plastic vent stops that fit in the channel above the sash. One pair of 1" wide, and one pair of 1.5" wide. I'm quite familiar with the operat ... (cont.)

I could not locate the attached pivot bar on your site. Thanks.

26 4 HK Caldwell

22" LONG HAS A MARKING ON IT (21 C )

I need two Caldwell channel balances. Part number 25-9 GS.

27 1 FL CALDWELL is the part no. shown on channel which is 1/2" wide and 28" long. It appears to be a S380 but the S385 &S390 look similar and I can't tell the differences. The window weighs 24 lbs. Thanks in advance - would obviously like to identify and get ordered/delivered a quickly as possib ... (cont.)

I recently ordered window latch part number 90-267 and it was too large to fit into the slotted track. I do not have one to show as an example. Any suggestions?

I'm looking for a replacement for one of my window balancers. This is the stamp included on the balancer 26 4 BT Caldwell. Hoping to get a specific part to replace it since it isn't obvious how to replace it. Thanks!

Hi, which balancer do I use?,1990, double hung, 31x31, thanks!

Do you know where I can purchase the 3/8" x 1/2" wood trim that goes around the inside glass on a Weathervane window? The repair company won't sell me any.