Viewing all customer Discussions for:

Other

Hi, Do you have the part shown in the pictures? What part number would I order? Thank you! (32 4 FP Caldwell)

I rent a small house in WA state. I am a disabled single mom and worry about this one window I have that has always had a broken lock. Now that someone Has been digging through my garbage looking for Prescription med bottles and leaving them out in my driveway!!!! I am scared someone is plan ... (cont.)

Please let me know if you can supply

I submitted tags from the window hoping you can identify the size of the balance rods I need to replace.

Hi I'm looking for this one, also the one for the opposite site

my window doesn't stay up. it has coil balance shoe. The spring has broken. I would like to replace the broken shoe. However I can't remove the sash from window frame by tilt the sash 90 degree. the shoe has no open top. How can I replace the broken show? Thanks

Do you stock this by chance?

Hello, I bought the S140-13 Quick Tilt Balance thinking it would be a drop in replacement/upgrade for my broken coil balance. So far it seems the width and depth are about right (haven't fully tested the fit yet). Unfortunately when I tested the fit of the sash pivot, the S140 shoe is just a ... (cont.)

So easy to replace,just had be sure that I ordered the right supports,took me about 10 minutes to install the 2 new ones after I got the mailed package,I bought 3 sets of pairs just in case any others break. Fast shipping from Swisco & a super low price, sure beats eBay.

I have a Care Free window, single hung operating lower panel, that has the balance bracket broken free from the panel/frame. The balance appears to be in working order. What it the cure. Can I buy a new lower, operating pane?

Hi, sir,I would like have two balances with these ends, 15-193 and 19-038. The number on the previous balance is 2840. Thx.

We have some older aluminum windows with spiral balance mechanisms . They are sticky and not working well. We have soaked them in solvent. Is there a lubricant you would recommend to reassemble them?

The metal length of my balancer is 28 5/8 inches. The width of the pulley end is closer to 1" 3/32. The stamp on the metal says 28 5 in case you can't read the picture. I can't find any other markings on it. The clip at the end of the cord is different looking than your S385 series pictures. Do ... (cont.)

I sent the picture of the shoe attachment, top attachment as well as the markings on the unit. I think it is a series 350. It is 28 inches long. I would like to buy several of this configuration. We are in Redwoodshores , Redwood City CA.

This is the part that I identified for my screen door replacement. Is it possible to just order the latch and not the whole assembly? The part is stamped with a 2 and a 777V thanks, Jim

I would like to purchase replacement window spring assemblies for a St Cloud Window, which is approximately 30 years old. This window was new in 1982. This is a vertical single hung window, which is non-tilting. Only the lower sash moves up or down. I would like to purchase new channel s ... (cont.)

Lokoking for roto m1260 parts

Instead of using an Acrylic Sheet Cutter could I use a Razor knife? If not what is the difference? Thank you

Has the number 11 then 80/0 and XI on the window. Also sash balance has number D44 7P27 377 stampoed into housing. Can you help with date and replacement part number?

I want to replace the multi-point lock but the lock is broken while the window is closed. How do I open the window to change the multi-point lock?