Viewing all customer Discussions for:

Other

Looking to replace the channel balance. Its 29 inches long. The photos are attached.

I believe these are Carco casement windows from 1993. The windows themselves are in very good shape but the plastic that surrounds the traveler has cracked and broken away. Thus, the window pops out of the track on any pressure is applied

We are renovating our kitchen and keeping the original Pella windows; still in great shape. I am looking to replace several of the casement window crank handles. Photo of crank is on graph paper with 1" increments. Any help appreciated.

I haven't succeeded in getting these things out of the frame - I might have to make a cut in the frame somewhere to slide them out and examine and measure them. I'm looking for the correct replacement part. Our windows are decades old. I want to try to make them all work again, many of them are stuc ... (cont.)

Hi I am looking to fix these parts on my tilt in windows (the lower sash) of my garage windows. The window falls out if I try to tilt it in due to the broken part. The window will also no longer stay up when opened. The coils and windows no longer have any identifying marks or stamps. The window pa ... (cont.)

Need a couple replacement Bonneville casement window crank arms. These are from windows installed in 2003.

The steel channel is 25 inches long and five days of an inch deep. One side of the window failed when the rivet holding the spring bent and pulled itself out of the holes which held it. Of course I'm going to be replacing both sides of the window. As best I can tell my son and I installed Windows 2 ... (cont.)

I need to replace both of my balances for my Viking window.

Hi. I was inquiring as to whether you have this patio door handle. Stanley PAT 963505?

I am looking for the bracket circled in the picture. It attaches to the back wall of the inside of the desk to allow the drawer to roll. I have the long arm Mary

Roughly 12.5" from end to end, recessed into the door. I am not sure if I need a new mortise or a new lock/handle. The door lock needs to be jiggled up and down for it to unlock. Any ideas on what needs replaced? thanks!

Hi do you have this door handle replacement? It is 13" long and the screw holes are 12" apart. I think the top screw broke/ripped

Truth Hardware 10" 2 Right Swing 1 Left Swing

Hi, I'm looking for a 96" bottom concave roller track for closet doors with mirror. I need three of them. Based on your website the company used to sell them but no longer carries them. Do you have any alternatives or a lead on where I can find them? Thank you. -Rosie

Hello, the outside portion of the sliding patio door handle broke off. The sliding door is heavy and needs a good quality handle. do you have a suggested replacement. thank you

The inside handle broke off. All other parts seem to be fine.

serial #584858; door installed 2001 cover plate is 8 x 1-5/16" 3-3/4" between centers of handle and lock shafts

The parts that slides through the track were broken

Hello, I need to identify the correct part number to replace four Sash balance for an Anderson windows from 1980s. thanks

Need help identifying this roller it measures 3" by 2"