Viewing all customer Discussions for:

Other

Looking for a pivot pin for a bottom sash for a double hung window. Picture of sticker on window in the attached upload.

Need part

Both half inch 34 - 3 Fx cmc 7 28 - 4 gx cmc 11 all same end fittings on both sizes

I need a new slide mechanism, left side for a KK casement window.

to much rust to see any markings. Very hard to remove. I notice the pin that slips inbetween the aluminum frame, had to bend frame slightly to remove wheel.

Hello I have been searching for the correct size Mortise for my Patio Door with your Model number on it . Are you able to help me find the correct part? Thanks

Pls tell me which balances I need to replace these. My home was built in Riverview FL in 2017 w-7500 sq ft., and 26 windows. The windows are now starting to be difficult to open and balance components are breaking (plastic tips, springs, etc.).

Hello, I am looking for a SGD track for a Warnock Hersey series 870. I have found close to what I need at other retailers but the closest match i see too high from the bottom to top of rail at 7/8". The original broken rail is 5/8". Please let me know if you have something that might work. Mike ... (cont.)

Double hung window won't stay up when in open position. The balancers are broken or missing. The sticker says: H-R20-48x77 H-R25-44x60 Serial Number: 9980/9980P See photos for details.

It's a lock that sit on my storage back unit. It's all broken tho i want the same or something that will fit:) thanks much

I have an American Craftsman 72"x80" 50 series Left Hand sliding door. I need to replace the handle with one that has a keyed entry.

The rubber seal at the bottom of the shower door is "shot" and needs to be replaced. The seal is one inch in width and has a rounded top that slides into the aluminum channel. The rubber seal is approximately 26 inches in length but long ok it could be trimmedThe round top that slides into the chann ... (cont.)

Looking for this window roller.

I need help identifying this part. I need 2 new hinges.

I'm trying to find out what replacement roller I will need for this sliding door. The old one must be broken since it can no longer be adjusted.The attached photo is all that remains of the warranty tag. I hope there is enough info to recommend the correct parts.I will need a set for one door, prefe ... (cont.)

see photo

These are for two different windows. Numbers I found are 11600-17,E20 927 9 87. 11600-17,D40 7?27 885

Looking to replace this lock.

Hi I'm looking for a replacement tile latch to replace the one shown in the pictures. Thank you

Hello, I need to find a door handle like this for a sliding glass door. Thanks.