Viewing all customer Discussions for:

Other

Hi - I would like to buy new channel balance for my non-tilting window. Some stats: 1. 1/2 channel width 2. 30 inches in length 3. There are markings, it says: 29C USB thanks

I need a sliding glass door handle with 3-1/8 spacing between screws

Hi, I'm looking for a replacement for this part. It's the sash pivot on both sides of the window. The one in the picture is broken. Is 26-423 the correct part? Thanks.

I need three of theses

Pleas help my drawer broke...

The doorhandle on my slider glass door looks outdated. I'd like to swap it out for a newer black handle.

I think the part may be called the coil balance shoe for a vinyl window. It appears that the one in the window photoed above is broken or locked into place at the bottom of the sash. Can it be removed and replaced?

I'm looking for a standard keypad controller for a Roto motorized insula-dome skylight.

i have a simonton window with a broken part, as seen in the photo

Series 152 Coil Balance 10bs coil

Please advise if you have a replacement handle. Mortise lock and inside parts are fine. Outside handle has a broken screw receptor. Thanks

I need new arms. I can see on the current arms. Entry Gard. top looks like 755. bottom of arm look like. 30242R??? I think I need part numbers: 39-031 and 032, 39-107 and 39-205 Can you confirm please before I order. Thank you

It's about 3 inches wide and 1 in and 5/16 deep

I am looking for 3 covers and 5 cranks. The brand is Casado.

Hello Friends, my mom has Truth crank open windows and this plastic clip broke recently. Hoping there is a replacement part available. Number on window is 31401 - hope that means something to you. :-)

Attached are pix of the operator. Arm is 9 1/2" center to center, 9/16" roller on the end and widest screw holes are 3". No ID other than RH LH and the number 30350 on another arm attached to the window. Searching I find part numbers 39-027E and 39-028E to be a close, am I correct? Thanks. ... (cont.)

Shoe is 2"x1-1/4x1/2. Channel (bar)is 2-1/2" with one hole in approx the center.

how do i make this a key lock?

Hello, I am looking for a part that holds the locking mechanism in place for an alside casement window. There are 2 plastic parts that holds the locking arm mechanism in place. The end of one has broken off so the locking arm falls out of alignment. Thanks.

I am looking for this dresser drawer handle. It came from a Furniture traditions dresser. It is a drop bail style 4 & 1/2 inches center to center.