Viewing all customer Discussions for:

Other

I need to buy several of these latches also need info on removal and installation of the replacements

Hi, Looking for replacement top sash pivot bars. Mine are plastic. The are 2 5/16" long, 3/16" thick, 5/16" wide but the distance between screw holes seems to be about 1 1/8" to 1 3/16". Distance from end to closest screw hole is 7/8" and to farthest screw hole is 2".

I need to buy complete set thanks for your help

I need to replace this screen door handle and I'm hoping you have this part or something close to it...

Need 2 S795-28c balances. 1 inch wide shoe. Open cam. With a hook top. No hole in vinyl frame. Could you give me a price on that ? Also I have 2 different windows that need coil balances. The coil balance is 1/2 inch wide with a screw hole like s190 or s175 with a stamp 3 on it.

I am looking for a faucet, handles, and drain to fit my powder room sink. It is a 6" spread and the sink is from the early 1940's. I would like something similar if possible.

I need 2 weep hole covers for simonton patio doors exterior.

Can you identify replacement part?

Nothing

Hello,From looking at your website I am wondering if you could confirm that tilt window latch, left hand #26-243 and tilt window latch, right hand #26-244 would replace my a/n photographed tilt latch (left hand)On the back of the tilt latch is 092 and 10C and Pat.# 5,139,291Thank you for y ... (cont.)

The number on the back is 021000 08 06 - MADE IN USA The bar is 16"long The window opens upward

I need the part shown in the photo below.what is the part# and how do I order it?

Only marking found is a number 5 in a circle

Double hung window sash lock replacement. Looking right and left side.

replacing spring balance in old window

need to replace this but I'm unsure which one to buy

Hi, i have a 30 yr old Stanley dresser that 1 drawer needs totally new slides. They 2nd drawer need the missing back part.

Hi, I'm looking to purchase a replacement of the item in the photos. It's from a sliding door that was probably installed in the early 1990s. It's about 2-3/16" long, 1-1/2" wide, 1-1/4" deep. Any help is appreciated. Thank you, Ari

Good morning, Do you carry this particular window crank or something comparable? The windows are pretty old. I will need 2 of them. Thanks for your help.

Hi, I ordered and received this replacement latch kit. I was able to use it with the old stem. The new stem (key) was too long because this is a keyed door. Do you have a kit with a shorter stem? I'm not sure if the old stem will last. Thanks, Bill.