Viewing all customer Discussions for:

Other

I need replacement hardware. The nipple the crank attaches to has sheared off. It looks like metal fatigue.ThanksGary

Need a part number so I can get some ordered for a remodeler. Saw some on the website but weren't sure if it was an exact match. All 3 sides measure a half inch. Thanks in advance!!

Need to replace the locking mechanism.

I am assuming the spring is broken inside, since the hook piece will come out but not easily. it is a key lock and flipper lock, probably 15yrs or more old.The door is 1 3/4 wide.The length of mortise plate area is 3 1/8.Can you tell me the correct replacement part.Thank you for your time,Lori ... (cont.)

Would you have this handle or a comparable unit that would replace this door handle?

I think it's older.block.n tackle balance, I have 14 windows I need replacement for

Hi there, not sure of part number but I need 4. 2 right 2 left

replacement spring

I am trying to find out what this part is.

gasket that goes between the aluminum frame and glass on inside and out, glass is 1/4 and gasket width that sits in the space is approximately 1/8 it is wider on the part that goes into the groove in the channel, this is on a kawneer commercial door from approximately 1970-1980 time span ... (cont.)

Please provide replacement part number for items shown in pictures attached Thank you Joe

Need top latch, pivot bar, foot & coil springs

The little white plastic bit is broken, so when the window is cranked toward the shut position it jumps off the rod.

Hello, I need to replace the tracks for these bottom sliding door guide. Which tracks should I purchase for them? I also attached one of the tracks (pic 3) for reference that was used on the guide (pic2).

Hello , Are there knob or folding style crank replacement for older Milguard window.?

please help identify

We are looking to replace this part, the door is ProVia, but I'm not sure of the model number.Thank you for your help!Sue

Hello, A client broke their potio door handle and mortise lock. We identified the handle to be from swisco, but I did not find it jn your current catalog. I have included pictures of the handle and measurements of the door and lock. Can you please help me identify what lock and handle I can get to r ... (cont.)

Metal section is 27 inches long. Marking on the balancer is "20-4 KA2 YXX 7" Can you please help me identify the part number to order this balancer replacement?

Hi, please can you help us find a replacement for this wardrobe wheel the wheel part has jammed up and snapped off if you could provide me with the part number and price and where we may find one I'll be very grateful thank you in advance for your help kind regards Steve