Viewing all customer Discussions for:

Other

Pella Fort Wayne, Indiana referred me to you. I have a door handle that the locking mechanism will not work. I have three pictures I am attaching. This door was installed in the latter part of 1990. Please let me know what you have available. Thank you

spiral balances for tilt alum secondary double glazing. weight of sash is 11kg length of tube is 34.7/8 inches dia of tube is 9/16 or 5/8 according to your website sash windows have fixed horns which home into flat slot. I make a guess that these are not original due to 2 animalities 1 screw and ... (cont.)

Do you know where I could get replacement hinges?

The silver part is 22 inches long.

Hi I need to replace my balance and I can't make out the stamped markings except maybe it's "35 3 IS CALDWELL"? Attaching pictures. Thank you!!

Can't seem to find a replacement for this window screen frame corner. 1.7 inches in side length. A bit less than 3/16 inches in "height" A bit less than 7/16 inches in "thickness" Attached pictures with markings.

This a a clip that has a spring loaded piece that keeps the sash centered. You compress the spring loaded part to slide the window over to remove. 4 parts per window, 2 top, 2 bottom each length.

Please let me know if you have replacement parts for this screen door roller. I believe it is from a peachtree screen door. Thank youSimona

Need to replace the lock (original fell)- can you please tell me what to order? Handles are in good order just need the mortise locking mechanism.

I am looking for the part in the picture, but smaller in size. The length of the rectangle is just smaller than 2 1/2 inches. The only parts I have found are for larger windows. Can anyone assist?

I need 6 cranks for Anderson casement window, the part 3 as far as I can tell is 7191A8

Handle w holes 3inch on center. Latch mech about 2.5inch Screen on outside face Latch hole on inside of frame

Windows Slide UP. Picture of working lock on window. When locked, there is a red circle showing locked. Picture of lock on table is the part that came out/broke from the window. The 2nd part is a white metal bracket on the fixed pane (not pictured). When closing, there are 2 T shaped pins on the ... (cont.)

I have broken and bent springs on my balances for one window. I can reinstall the balances if I can get the springs. There were two 3.5lb and two 4.5lb springs. The springs say 35". I can't identify the assembly from the website if I need that. I also need the tilt latches for 1 window. ... (cont.)

20121 is part #

I have an installation of a bi-fold closet door in very close proximity to a hinge door that opens over the bi-fold. Is there any closer specific fo a bi-fold door? After market closers that I have looked at do not seem applicable to my situation. Thank you for any suggestions you may have. Greg ... (cont.)

Looking for a replacement for a part that is attached to the bottom of a top hanging sliding screen door. It is a rubber strip that inserts into the door frame across the entire width of the door. The piece has hard plastic channel pieces (pictured). This door is missing one or more of the channel p ... (cont.)

Looking for new door handles are compatible

Hi, For single hung window. The holes are 1 1/4" cc. Thenumber on the latch is 10068. Thank you

Need counter balance springs