Viewing all customer Discussions for:

Other

Hello, I have a patio door that the latch fell into the frame as I was trying to take it out and see what's wrong with a hook. Please help me find the proper latch. The fitting is only 2 1/2 inches in length and .5 inch wide. Please take a look at the pictures for measurements and more information. ... (cont.)

spring locks are broken to allow window to hinge open for closing. they are recessed into the window so not sure how to get them out for replacement. they are 2 5/8 x 5/8

Looking for a tilt latch replacement for a jeld wen window

Looking for a plastic weather seal that goes at the top of a double hung window. Wind is from the mid90's. Also looking for any other reubild parts you might have for these windows.

Hi, I am looking for the End clip (grey looking in the picture) that attaches to the ends of the window joiner. It is a Silverline vinyl double hung window with an attached transom like window extender at the top.

home decor innovations 64564-001 400 lbs impact testfrank

Good morning I need to identify the store handle and the right spacing, it has ripped on the top and I do need to put the latch in that I ordered two years ago. I have struggled with the latch to try and get the hooks to retract farther down. So therefore I never put the latch in which I think is le ... (cont.)

Hello, I am looking for a casement window weather strip that's attached to the edge of window/glass section. I used a metal ruler with 32th divisions and the bubble portion seems to be 6/32" (3/16") and the "base" 5/32" or 6/32". I could not find a weather strip this small in the website. Are you ... (cont.)

Hi, I am trying to purchase the set of hinges, picture attached. Kindly let me know if you carry this.

The left terminal housing of one of the windows broke and we need a replacement part.Window installed by Sears, Weatherbeater windows, attached label of the windows and broken partThanksDavid

My neighbor bought S385-33 Option 3240 33" rail. Winged bottom and top guides. Mine that I pulled out do not have the little hook shown in the picture on your website.

Can you please tell me what I can use to replace this?

I ordered 26 lb series 140 quick tilt , triple spring balance system and I think it is too deep for my windows. I am attaching photos of my spring system against a measurement ruler. The channel break has part # 5.704.165 stamped on it. The springs have0.35" inked on it and one of the springs has ... (cont.)

Need replacement handle

Hello, I am looking to replace this set with one that can be locked. It is currently locking into a channel in the frame Is there anything that you could recommend to me.

Hello,I believe these hinges are Mepla Hings 698.243.59.00. I understand that they are not made anymore. Do you have anything that comes close to them that could be used as replacement?Raymond

how to replace the left lower side guide?

I am looking for a drawer socket for a Scheirich PPW098 88. This socket slides on a metal anchor strip that is screwed into the back of the cabinet.

Do you have this part?

I need 10 ea. ( 5 sets) Spiral window balancers to replace Swisco crossbow balancer model S850-34. The windows weigh 18 pounds. Please advise.Thank you,Dennis