Viewing all customer Discussions for:

Other

The weather stripping on Pella door matches the spec on the 58-181 but doesn't do a good job at blocking drafts. Can you recommend another that would fit and might seal better?

I do not know the manufacturer of my storm door. There is R 5 marked on the back of the right hand latch, no mark on the left latch. I need both latches and springs.Frank

Can you please give me a part/model number to replace the Brocken latch lock shown in the attached picture. Also, does it cover in warranty? Thank you for your help!

Trying to repair several screens by replacing the plastic inserts in the corners. They are approximately 1.5 inches long on each side, fit into a slot that is 3/8" by 3/16". Pictures attached.

I have a 1986 age ranch with casement windows. many need new weatherstripping. the weather stripping fits into a slot on the frame. I have attached photos of the installed and uninstalled frame and also the existing stripping. The side weatherstripping is different than the top and bottom. ... (cont.)

need replacement weather stripping for neuma patio door. only numbers I have for this door is D305681-Swisco Installed in 2019 Order #2186562

the spring and the part that latches into the window itself are missing the window part is in place and it is of the standard window latch that fits into the balance. the window measurement from top to bottom is 54 inches

The roller at the bottom broke how do I remove this the screw?

Looking for this replacement part

Hi, I hoping to replace my crank window handles on my Milgard windows with a lower profile handle, such as a knob, so that my blinds will go straight down. Do you have a replacement part that would fit for me? Thank you, Fran

Length-32 5/8" Stamp 32 4. Photo Attached. Milgard windows Quantity-6

The thumb latches and tabs that hold the top of the lower tilt-in sash in the track when it is raised are broken. This allows the window to fall in when it is raised. Can these latches and tabs be replaced?

May you please provide a quote to match the uploaded photos.Shela

I am trying to replace the casement opener shown in the picture submitted. The main gear in the assembly is stripped. looks like the crank arm is 8 1/2 inches. Right hand crank (opens on left; hinged on right). Thanks for your help!Frank

I have an Inside Handle that is broken and I need a replacement. You can see in the photo where the latch is cracked at the pivot pin. It is similar to Model 40-150 except is has a lock. Do you have a version of the 40-150 Inside Handle that has a lock? Also, the Resilient Strike appears to be eith ... (cont.)

The one in the pics is 28inches overall and the metal is 27 inches long the metal is approximately 5/8 inch on all 3 sides. The plastic piece on the one end is approximately 1 3/32 wide. I will need 8 of these.I also need the same thing except the length is 21 inches on the metal and 22 inches over ... (cont.)

Hi,I am desperate looking for 8 of these to repair some windows. I would need 8 of them. The stamp on the side says 24CZ. Thanks Maria

I need this specific kind pivot lock 1 inch. I ordered 1 inch from SWISCO it does not fit.

Hi, I have slowly been losing these in my home and was wondering if you carried them Thanks, Ian

I am trying to figure out what these window parts for a Winstrom window are called? And is so do you have these parts available.