Viewing all customer Discussions for:

Other

Aluminum clips to hold middle bar of screen in place

Can anyone tell me where I can find this parts.

Need slider handle & lock

I need to replace the balance show (maybe the block and tackle balance) right side. Window is a Ply Gem 1500 Vinyl Single Hun. I don't have the part number

sliding bolt-looks like it has a upper sliding tab no lower sliding bolt is, 3.76 inch long, 0.25 thick, .425 inch tall bolt would also like the rubber gasket upper corner tab is .175 inch thick

Hello, I have Trico 1000 windows CB a D 91 the tilt latch slider works but the plastic piece that holds in the window snapped off. I need two replacements and instructions on how to install.

I need this type of door latch strike Thanks Karine

Looking for this vinyl window trim piece. Bob

This picture is of left side window because the right side window, which is the one that is broke can not open and then shut but you'll get the hint. We need the metal arm replaced for the right side. Can you help?

Looking to replace the lock 1st if need be the whole thing just having a hard time finding the right part.

Need help in identifying the replacement spring... It is a wooden double hung window... The top window is 36 inches long while the bottom one is 37 inches tall..

Hi, I have Legance II sliding patio door. It appears that the rollers are broken off and the door is hard to open and close. The markings on the door are follows: Legance 3 patio door. Type: DDSG Code: TRI-K-36 Additional markings: 86 DR6 LEG3 S 35-13/16x76-7/8-L 07-83643-01 SL 15796471 BS (thi ... (cont.)

we have two window cranks that are missing a part so they do not work . We need replacements for one right and one left opener. Can you help us and thank you.

Hello! I am trying to find a replacement part for a broken window opener. I see some online that looks similar but maybe you can direct me to the right part! Thank you so much!

Coil balances broken. On the cover plate for the most part is showing numbers 1 and 7. Another one 7 and 8. Same size windows. The sash weighs 21,8 lbs. it will be for four windows total replacement of coil balancers. My name is Ray. Thanks.

We need a replacement parts for these pivot shoes, clip?, and hook?. I believe its pivot 15-191 and S160-7.

I have an old Cole Sewell door without a handle. 1-3/4" between the screws with a hold right in the middle for a spindle. There is no existing handle for me to send a picture of. I don't want to bother with new holes so I don't need a deadbolt. What do you suggest?

Hello, I am looking for Pella sliding glass door handles. I only need the exterior side of the handle. I have attached photos. 7 1/4" attaches on the door, 9" handle and it's 1' wide at the base. I will need 6 exterior handle-door pulls and 12 rubber bumpers that screw into the door frame. Pict ... (cont.)

Caradco LH crank assembly. My identifier is CARADCO printed on the screen photo Thank You, Dennis.

I'm seeking a window bead that is 8/16 by 8/16