Viewing all customer Discussions for:

Other

my doorknob is loose?I believe it caused by a failed spring to hold it into position. Will you be able to help find the spring or replacement for the knob? Thank you!

Weatherstripping from slider doors, possibly weathershield brand.

Can't find any numbers on parts

I need to replace the outside seals around my bow crank windows. I looked on your site and didn't find any that looked like this. Will you be able to help me find replacement seals? I installed this window about 20 years ago. I ordered and replaced the window latches from you last year. Keith ... (cont.)

Hi,I'm attaching pics of kitchen cabinet hinges. I've been doing a Google search, but nothing is popping up. No identifying marks that I could see. They are attached to Aristokraft cabs but most likely are another manufacturer. Your help is appreciated.R/Sam

Can you please tell me what I need. Thanks

I'm looking for a Anderson balance. It's a 950. Is there a cross reference?

Working on a house i believe was built in the late 60's and windows appear to be original however cannot find any marking or part numbers of any kind. Any help would be appreciated

Here are the pictures you requested to assist in the replacement . The strips are 1/2 inch and fasten under the outer edge of the window. The windows were manufactured by General Aluminum, series 1100-1450-1550-1900-H-R30. Does your company carry these replacement strips. Thank you very much for you ... (cont.)

Looking to obtain two of these rollers.

Hi, I am looking for the seal that goes around a plexiglass. I have added a picture of a cross-section.

Can you help me find these brackets for our Tractor sliding windows. They are about 12 years old. If the window is closed with the locking lever in the position shown it can break the tabs on the bracket. Thanks for your help. Space between screw holes is 2-1/4" space between screw hole and top edg ... (cont.)

I need a window balance. I expect that it is the same as you have sent me in the past. CUSTOM - S752-26-A91-Q0352 Name: 26C Series 752 Type B Balance This is for a pennco tilt in window. Please provide correct replacement balance information. Thanks. DaveD

Attached are pictures of a broken part that I need to replace. The last picture is an operable one installed

HelloI have an Anderson Frenchwood Hinged Patio Door and the lock does not work. I believe the part in the attached photo should have a spring that slips over it that would hold in a locked position. I purchased the spring at our local hardware store but it is just a little too tight. Would I be ... (cont.)

Hi, I have a large number of pivot shoe locks that all have broken cams. I was wondering if I can purchase the cams individually, without replacing the entire pivot shoe. The pivot shoe is the 15-178 model.

We need a replacement patio door handle.

Hi, any help identifying replacements for these (circa 1980's?) would be appreciated! Upper hardware appears to be a rectangular nylon slider, lower is rollers. Each locks in to a basic metal frame.

We have an old casement window. I don't know the manufacturer (hence my reason for contacting you). Do any of you recognize it? There's only one identifying mark stamped on the short portion of the split arm. The long portion of the arm is about 5 inches. Sorry I forgot to measure the mounting hole ... (cont.)

Good day! I am looking for a small plastic part that holds the window shut on a casement (crank-type) window. It measures 1 3/4" long x 3/4" wide. Screws are 1" on center. There are 3 on this particular window and helps draw the window closed. Any help you can provide would be most beneficial. Thank ... (cont.)