Viewing all customer Discussions for:

Other

The lock of my patio door broke and I'm having a hard time finding a replacement. No-name door

I would like to remove existing Handle and replace with a key lock handle. I have attached several pictures. My Questions:- Do you have a key lock Handle that is similar in design?- If so how much is it and if it?- If it does not work can I return it?- How hard is it to change out?- Will I need to ... (cont.)

I am trying to determine which channel balance this is. It is 23" long and 5/8" wide. It has the number 223088 on the back followed by 081 with a tiny V as a superscript.

Coil spring and balance shoe broken. #407 is stamped on coil. All four need replacing.

measurement center hole to center hole is 10 1/4 inches. Bought 82-265-Multi-Point Mortise Lock with Face Plate, 11"

I it's a block and tackle 26bc little circle with a plus k n pictures are attached it's about 27 in Long it has a little hook connector on the top and a regular circular connector on the bottom

Not sure which one on your site matches. I need at least 10 of them One pic shows a broken item. The other appears intact.

I am looking for a replacement

Match latch

Match balance

Can you help me find this screen door roller part? Ours is broke. I've sent a picture. Thx!

Looking for an 8' section of bulb seal for a Pella slider.

I am hoping you can help. I have an old (decades) Peachtree Patio Door (3 panel). The door on my model does not slide, it swings open. I am looking to replace the door handle assembly. What I am looking for is a separate door dead bolt that is keypad/Wi-Fi/fab/fingerprint activated. Any com ... (cont.)

Hello. I am looking to replace a pair of channel balances. They both had same stamps. They both measured 21" x 9/16". It is for a double hung window

Need replacement Milgard Channel Balances for older windows (2003) Model number 26 4 bsi op. 28 inches long including plastic wings (see attached pictures). Where can I buy them?Michael

This is on the part that raises the window up the cover on the end it's tilt windows

Do you have these parts in stock? Old patio doors?

The wheels I am looking for are Identical to your catalog Item #81-258S Except for the diameter of the steel ball bearing wheel. My Pictured item removed the door measures 1 1/4". My question is, is there an identical item as the 81-258S with an 1 1/4" wheel or will the 81-258S with a 1 1/2" ... (cont.)

I am having trouble identifying my windows, but particularly I need some replacement latches innkeepers for these windows that were manufactured in 2006 The tricky part is that the keepers are beveled because the window sash is also beveled The keeper is just over 2- 3/4 inches long The screw hole ... (cont.)

Looking for an Anderson screen door, bottom hinge with the pins sticking up out of the bottom about 4 inches and the door slides onto it. I am having trouble finding this.