Viewing all customer Discussions for:

Other

Hi I cant find this kind or pic anywhere, can you help please?

1. Length of metal channel is 25.5 inches 2. Stamp is 25 4 PL in long dimension. Transverse dimension B.S.I. 3. Milgard manufacture, roughly 2003? 4. Would like two (2). 5. Window weight 27 pounds.

Length 26" is measured only across the metal part, and does not include the plastic parts on both the ends.

Need help identifying

Do you have a similar replacement roller

Why do we have so many broken plastic parts in our cabinets?

i was changing window balance and then realized this piece is messed up and i dont know what its called

Roller pack for aluminum single glass sliding door, might be from 1979's. Do you have st stl cap for the roller to ride up on ? Also the little plastic end caps that help push dirt away from rollers Thanks

I believe your company used to fabricate these but not entirely sure. Cannot find them anywhere at hardware stores.

I need a replacement for this part.Emil

Attached is a window lock that I need replaced. This is off an Anderson Storm Door. Lock is hooked to the glass panel and locks into the bottom of the screen to be able to pull glass panel down and allowing the window screen to take its place. The picture is missing the top locking portion. Hope ... (cont.)

We purchased these windows a while back from Home Depot and are just now installing them. The one has the part where the window lock lever inserts into that is bent/warped. Is there a replacement part for this?

Hi, sorry I don't have better pucs at the moment. I was hoping you might be able to ID the door from these lower guide pin pics and provide a parts list for all the hardware. Or maybe point me in the right direction for how to ID them, I couldn't find a brand or anything. My parents and several of ... (cont.)

Double hung vinyl window replacement locks 26mm x 4mm.

I am in need of 2 drawer track brackets. As you can see on attached photo I have 2 broken brackets. This is for a 2 yr old bathroom vanity.Bracket is approx 1.75in wide by 1.75in deep if that helps.Thanks,Dave

Looking for assistance in ordering the correct replacement parts for Milgard channel balances. They measure 21" in length and the stamp says 20 3 JV CMC 2. And advice would be great.Emily

I am looking for the correct weatherstripping for crank casement windows as in the uploaded photo.

can you lead me in the right direction? window pivot bar.

Looking for a replacement part for Sash Balance on a IWC window

Dear Swissco, We have three windows that are affected and two of them have short handles and one of them has a long handle. This to inquire if you have the parts we can use. If this helps, here is the original serial number for the smaller handle: C-31-56-1/2-1650 ( need 2) The one of the long ha ... (cont.)