Viewing all customer Discussions for:

Other

We have Oldach windows in our home that was constructed in approx. 2000. Is it possible to purchase T-Handle cranks to replace our crank handles (attached photo of existing crank handle)? The existing handles have the number 45054 marked on the inside (it would be visible on attached photo 6454.jp ... (cont.)

I am looking to replace the wheels on my sliding screen door. I believe you have this part. See the photo attached. If you could give me a good suggestion on what part to purchase that would be great.

I need the window mechanism and the crank handle.

these windows are made by Vetter and have a part which is broken on both sides. not sure what the name of part is, but a small metal rod at base of window slides into the hole at bottom of the piece. the top hook is broken off (and still visible in window slot, although it is sideways) , but shoul ... (cont.)

I submitted previous photos about this project. I ordered 4 - part # 84-106.I replaced the rollers at the top of the door easily.These pictures are for the rollers on the bottom of the door. they seem to be different than the top rollers. There are screws on the edge of the door, but they can't b ... (cont.)

Looking for ADA handle or longer handle crank. Hard to turn crank. 5/16" diameter

need to replace balance in non tilt window, tried going through different company but found balances the had were not correct, were tied to retaining hook instead of crimped, causing retaining hook to catch and then snappedwidest part of channel is 5/8 inmetal length is 27 in marking on metal is 26 ... (cont.)

balance system for 1993 pella double hung window

I am the homeowner and can't seem to find the right outside top piece for our newly installed window , the pieces have become brittle an broken. We need them in clay if possible. Approximately 1" wideEd

You have helped me before and looking for your guidance again. I bought a home with double french inswinging doors that both need new bottom sweeps. I cannot locate a name on the door, but have pictures and measurements (left side 34 5/8", right door 34"). How can I send you some photos so you can s ... (cont.)

More pictures of Anderson sliding glass door weatherstripping. The technician asked me to take more pictures to show the profile of the weatherstripping.. As I stated before in my previous email this door was put in in the early 90s. Thank you.

Hello,I was wondering if you have a replacement kitchen cabinet hinge pictured below. If not do you know where I might be able to locate one? I have been to multiple stores in search of this hinge with not luck. Thank you very much, Donna

Old casement windows (20ish years old) need replacement weather strips. No brand markings to be found. Searched the internet for replacements without luck.

I need to replace the rubber strip which seals my Aquaglass glass framed 22 1/2 inch shower door. The metal part is 22" long and it is 1" 3/8" wide

Can anyone help me identify what this part is and if there are any available?

Anderson window crank 7073B right and left

Looking for replacement pivot guides and springs.

For old 25+ years Gorell vinyl replacement window, I purchased a different model that came flush with the bottom of the sash and what I need is one that drops down below the sash with a 3/16 Tee. Possibly a 58-164 or a 58-171? Please advise Thank You Carl Lind

"Atrium Door Company" Sliding Screen latch release handle broken. Swisco 83-129 is proper dimenion but the internal parts are wrong

I need to replace some broken parts such as pictured. The coil spring is 1/2" wide. Can you help me identify so I can get correct parts? Thank you