Viewing all customer Discussions for:

Other

Are these pics enough the find this lock. Need Replacement. Dave

Hello, do you have this weather stripping in stock. The windows are at least 20 years old, I think. Thanks Charles

Could you help me identify this part looked like a 58-182 but not sure

The pivot bar in my vinyl sash window sheered off. I am sending photos of the pivot bar on the other side and the part in the frame (lock shoe?) that the pivot bar goes into. I may need both parts as I can't get the piece of sheered off bar out of the lock shoe on the "bad" side. Thank you so much f ... (cont.)

I have a left and a right need new saddles and pivot hardware please inform ASAP as I need to order them from you.

Could you please help me identify the reference for the tilt window latch featured in the attached document. I would need the reference for both the right-handed and left-handed versions of that part.

Need 2 left and 2 right opening Long arm is 12 inches Short arm is 6 inches Crank mechanism is 4 inches long

In first photo the black connector with the two posts broke. Second photo shows undamaged unit. It mounts on the bottom of awning window and connects to window crank. I need 10.

I am looking for replacement parts for my dresser drawers. I need the sliding track in the first image the one that stays in the dresser not the track attached to the drawer. As well I am looking for the KENLIN RITE TRAK 2 on the front th/ere is the number 168 and on the back it says US PAT NO 6,485 ... (cont.)

I have several pella casement windowsinstalled in New home built in 1989. Most are hanging out of plum while the frames have stayed plum. Lifting up and down while open you can see the white guide at the top is sloppy. Bottom guide stays intake with little movement. The support hindge measures 11 an ... (cont.)

great lakes windows has told us to source parts from you because they no longer make these latches

Looking to Replace Torque bar on bottom left of photo and also the white nylon bracket and part on top left

As requested, I attached a photo of the bottom window seal.

Re door latch 83-040.. can you tell me the length of the little silver latch itself and how far it extends past the handle once installed. It looks longer than all others that I have looked at, which is what I am looking for. Thanks!

Looking to replace broken parts on my hand cranked window. The lock is in two pieces - one with number P-6200-25A. The flip down and up mechanism on the lock does not have a number in it.The hand crank has this number on it: C-1060-03A and there's a number 1 under that number.I couldn't find the man ... (cont.)

Hi team, do you carry this casement crank? Its rather small I have not seen a handle this small. Do you carry anything similar? Thank you

Parts information: This window is roughly 14" wide and was installed around 1994. The handle has 40085 and 24 printed on it. The window operator has Pat.No. 4,840,075, Made in the USA, and TRUTH printed on it. Problem: The handle and the metal shaft from the window operator slowly spin out of the ... (cont.)

my pivot bars that I am looking for are 2 1/2 inches long. They are tapered down at the very last 1/4 of an inch.. they are 5/16 of an inch wide down the body of it and 3/16 of an inch thick . The first hole from the top end of it, which I am referring to the T at the top is 1 3/16 of an inch to the ... (cont.)

I am looking for plastic drawer guides. Thank you!

Hinge below is in a Sligh printer cabinet/bookcase. Have researched at local hardware stores and found similar ones, but not exact. Die cast angular arm is 1" Moving arm is 3/4 to 7/8"