Viewing all customer Discussions for:

Other

I want to turn the sliding door to one that be use with key.the hold size is a 4 15/16.

Need to replace item.

Trying to locate this part for repair the outdoor awning.

It's for the opposite window. I had to force it closed because it fell off that track. I can take a better picture if need be, raining outside at the moment.

Help

I am looking for a set of replacement rollers for an 8' Tall JeldWen patio slider. The door glass code is: G505466199721 and was built in 2005.

looking for a Vetter Patio Door Hinge. See photos

after i replaced the block and tackles on my up and down window these plastic stoppers at the top of the window fell apart. window is a jordon which is probably out of production, 20 years oldjoe

I think my casement window operators are dual arm Truth entrygard in bronze color. Can you please verify before I order a lot of them? Thanks, Richard

Metal measures 27" long and just over 1/2" deep. 1" bottom plastic. Stamp is (03/8) Unique 26-0-30 and I have been unable to determine which is correct replacement. I need 2.

Hi! I'm looking for this part. It broke off my Millgard window. Do you have a replacement? This piece is 21" in length.

This is a roller for a therma thur patio French door it's a sliding screen door .The other half is broken also It's held in by two screws and the metal bends at the screws I hope all this is helpful Screen about 4 yrs old It does have a v on the metal Thanks Tim

This is on an old window in a persons sun room. I can not find any numbers or markings on them.

Pivot lock shoe that goes with 26-241 pivot bar.

Hi, I spoke with your customer service department. They stated I needed to email photos of the length, width, and color of the end pieces. Please see the attached photos of the balance indicating the length, width, and color of the end pieces needed. Please let me know what I need to do to get ... (cont.)

First picture: Pull is broken off, 5/16 thick, exposed corner size is 7/8. Marking is 808 Second picture: Believe it's an Andersen, 3/8 thick, flange is 1/8 of an inch from edge, marking is A894.

Looking to replace current locks, pics enclosed with ref lock set . Can you help with what I need

please let me know if you have it. Thanks, Jeff Amerimax is the window manufacturer.

27" channel from an Amsco non-tilt window. Probably made in 2012. Need 2 balances.