Viewing all customer Discussions for:

Other

Need weather striping door is 28 years old

Hi?see pics for model/serial number. Need the attachment hardware for the crank mechanism for where it attaches at bottom of window. Also need the left and right side hinged support hardware (?). Picture is if a functioning window ?the other I found out the hard way was missing a good chunk of ha ... (cont.)

The bottom of the 't' is 3/16". The top of the 't' is 7/16 ? the bulb is 5/16 high. This is from a silveline double hung approx Circa 1994. Please let me know if you need additional information. This weather stripping is on the bottom sash where it meets the sill.

The part is 28" long the stamp on the part is 2790 and 30 there's also a an AG and 8.51 stamped between the 2790 and 30. I don't know the weight of the sash I'm hoping one of the numbers in the stamp would denote the weight. Both balances are destroyed and it appears the take out tabs are missing ... (cont.)

The holes 2 5/16" apart from one another.

Need a replacement handle for my Trapp storm door, approximately 25 years old...I have included a picture

I need a metal replacement or more latches.0,

The one in the pictures fell out of the window and I have 6 windows total to replace them in. All in various stages of failure. Some stuck at the top, some floating around in the channel. Please help me figure out what I need to order so I can get a handyman to replace them. Thank you! ... (cont.)

My crank windows are on the porch of a 1960's modern ranch home.1

I am looking for replacement locks for my Alliance casement sliding window. Center distance between the screws is 2". Do you sell them? About 1-1/8 wide Thanks, Ed

This one was broken off and you can just see half the screw hole,thanks in advance for your time!!

I suppose white beads can be painted over as well. I hope the caliper readings are good enough. If not, kindly let me know if I should add more photos. Thank you.

why is the top spiral balance of my window shorter then bottom one. Top = 28in Bottom is 32in. I order a S900-28 red tip and it should have been S600 red tip. Can I still use this for my window?

Our thumb lock no longer engages the latch. Looking for replacement and how to.

Hi - I am looking for replacement sash vent stops for my replacement windows. Purchased in 1998, Certainteed vinyl replacement BRYN MAWR II model. Manufactured by Advanced Window Systems in NJ. Thanx wayne

Looking for new handle - metal housing where side screw goes in snapped in half

I had ordered 8 (39-232), but they are too big. Order number 2073578

i'm looking for replacement sashes for 4 pella operable casement windows. the sashes are all 29" wide by 47"

I need to fin this pz or similar to this pz

I need one replacement casement window scissor hinge and handle. Let me know if you. Wed anything else if the pictures don't help. Thanks. Jim