Viewing all customer Discussions for:

Other

Hello, I have a pair of top lift cabinets, one of which no longer closes softly but rather slams shut. I took the hinges down and realized the pistons that slowly lower the cabinet face no longer produce any resistance. The only marking on them is "0809-2 T-K-3". I've searched through the Blum websi ... (cont.)

Looking for replacement of aristocrat hinge as pictured. Thankyou, Patricia

Hello,Please see the attached photo. I am looking to replace a black plastic window lock. It attached to the window, you pull out the tab to unlock, you press the tab in to lock. I cannot find this in the local store. Could you please let me know if you carry this? There is no manufacturers' name or ... (cont.)

i have American Craftman Windows, double hung, that were installed in about 1998. the spiral title balance still works, but the metal piece at the bottom that the window hindges on has rusted off. do you have replacements for this part. if not do you have any suggestions other than replaceing the wi ... (cont.)

Hello, You have the pivot shoe I need but I need the bushing holder as well.

The channel is 9/16 wide and 20 5/8 long (metal part only). I sent a photo of the stamp and the only identifying information on the window itself - manufacturer code Best Built (BBI-1). I'd like 10 balances if they're not crazy expensive. Thanks!

I'm looking for this slide, 7523-19/550/533 LH but will purchase a pair.

Ref. My order 2048438. These springs won't work on my 87 era millgard sliding aluminum windows. See attached picture of what I need. Can you help?

Photos show my seal. Closest on website is 58-187. Same dimensions but my bubble is a semi-circle

Egress window screen with broken or missing tabs to hold it in place.

I have 2 sliding glass doors, both ALI ADW-8 ASTM 2190-ARG. Both doors no longer lock, there for a replacement lock is needed. Which one do I need? Additionally, I am also looking for a screen door to add to the tracks of both doors. Is that part available for purchase? By the looks of the base trac ... (cont.)

I need help identifying the replacement parts for these dual arms. Please let me know if there is anything else you need from us to identify the parts.

Good afternoon -- this part is from the back of a drawer -- the middle has broken off, so I'm looking for a replacement -- it looks like there should be 3 ridges and the metal pieces sit on top of them

The middle of the plastic lift at the bottom of my double hung windows is cracked. The crack is about 1/3 of the length of the lift itself, and runs along with the length of the lift, so it's about 8" long. It's the piece that's attached to the frame and at the base of the window. The problem this ... (cont.)

Good Morning,I looking at replacing some arm cranks and repairing a crank that seems to be worn out and will not completely close the window. I'm enclosing some photos. I know this may not be enough information. Thanks for your help in advance.SincerelyConrad

Channel length is 32 11/16 inches. Stamp says 32 4 BSI 0A

The sealer (non-hardening) for the Casement Frame Rubber seal. I have the rubber seals (New). There is a white sealing compount inside the channel. locking to get of it (maybe a cartrige or 2) but don't know the name.

Hi, Looking for window stops that will work with a Thermal Industries double hung. 13/16" wide to the notched corner. 15/16" wide total. Short leg is 1/4". Long leg is 7/16"

It's a old sliding door that I don't know the name brand

I Need a left and right Channel Balance for a 2009 Hurd Single Hung Window. See two photos attached. The mark number is 30DS BSI V6 42.