Viewing all customer Discussions for:

Other

Our door handle is missing it's latch. We need a new door handle to use with 82-249 and 82-265. There are 4" from the center of the two screw holes on the door handle. There are four holes in the door itself. The top and lower holes match the two holes on the door handle. The two center holes on the ... (cont.)

Small square plastic piece broke that slid in upper track

This is a plastic piece in an older awning window probably from the late 70's early 80's. When the window is retracted, it helps keep the window tight to the frame. This one is in tact but I have others that are broken. If there is a difference, I need right and left sides of this part. ... (cont.)

I am looking for replacements for Alside double hung replacement windews, model 0601. I need new window tilt latches.

need 3 of these

Hello. I need help to identify what kind of balancer are needed for those windows? The balancer in installed on top of the window with 2 clips attached to the hook on the sash with strings on both side. I am looking for the balance and the parts that's need to fix the windows. If those balancer no ... (cont.)

Have Harvey windows that need balances replaced. See photo. Can you tell me what I need part waise?

Dear Sirs; We need to order these weatherstrips for Simonton Patio Doors - 2005. Need 3 Top Seals at least 69" Need 3 Side Seals at least 77.5" Can you please get us a quote for the above request? Let us know if you have any questions. Please contact me at your earliest convenience. ... (cont.)

Currently searching for a closet bifold door track with pivot bracket for two separate openings. One of the door openings is 48", another opening is 72". Looking for the track as well as bifold pins for this Stanley closet door.

2 1/4 length 5/8 " widest part 3/8" least widest 7/8" height

I am looking for the interior plastic "hanger" that the sliding rail of a base kitchen cabinet is attached to. This is a "Quality Cabinet" - about 8 years old. One picture shows how the bottom of the hanger snapped off, the other one shows the one holding the drawer on the left of the cabinet is s ... (cont.)

Thanks

Hello - Do you sell a replacement latch, pin, flat wall bumper to replace this All American Metal stall door latch ? The bumper is mounted on a flat wall vs. the edge. See pics. We need the pin also. Thanks!

Marvin ultimate tilt in double hung tilt sash lock. Oil rubbed bronze. marvin part # 10500787 I need seven..

Can you tell me if you have a glazing to match this one

House was built in the 90s. Two of these plastic catches have broken and I cannot find them anywhere.

I was hoping to replace a singular drawer slide on a drawer that is 36 inches wide by 14 inches deep. The current singular slide (wood on bottom & metal on top) does not seem to be able to properly support this large of a drawer with even a small amount of contents.I was hoping to change out the ... (cont.)

Hi on a search for the "side parting stop" for a Jeld-Wen sliding door (wood circa 2004). The door is standard 80" tall and seal runs along passive panel where it meets active sliding panel. It is 5/8" wide in total with a 1/4" wide two pronged snap in see below. Do you have anything that would ... (cont.)

One of the wheels are broke completely off the top. Do you sell this?

Attached is a photo of the label on the door. I have four doors total, two at 32" and two at 36". I can cut a 36" to fit but I want to ensure I'm getting the correct part to work with. I think this is the correct part: https://www.swisco.com/36-high-performance/pd/Thresholds_Door-Bottoms/58-189 Th ... (cont.)