Viewing all customer Discussions for:

Other

Vinyl casement linkage has a black plastic slider that Goes back and forth on upper and lower rail 2 uppers 2 lowers need to be replaced Wether just plastic or entire linkage/ rail we are flipping This house and can't close until repaired In addition I found other dead cranks 39-188 and 39- 187 a ... (cont.)

I need to replace this door handle and can't find anything like it.....any ideas????

Check to see if you have any replacements for these non tilt balance guides. They measure 5/8 x 15/16.

How to replace the channel balance in this window?

My extended arm length from center of rivet to center of 3/8 hole is 2 1/16 to 2 1/8 long, NOT 2 3/8! Please advise a replacement operator. Operator circa 1964.

Can you help me figure out what I need to repair this sliding glass door lock? (manufacturer unknown) Here's the situation: When I turn the knob from the inside handle it just spins. When I put the key in the key from the outside handle nothing happens. Now that I have the handle apart, when I st ... (cont.)

I am looking for a replacement piece for my broken Window Screen Frame. I am not sure they make it any more its 24 years old and I am not sure of the manufacturer. Do you carry Window Screen Frames?

Hello, Please see photos of the part I need to replace in my partition door. The hardware says Knickerbocker but I am unable to find this part. Do you guys have it or a suggestion on how to replace with a working door lock?

Can not seem to locate screen pins for a Marvin window screen. Seems everyone is selling 1 1/2" pins. Tried these but pins are not long enough.

Hello, I would like to ID and order the correct replacement part(s) for this channel balance, please. I've included pics of the window label and the channel balance. The channel balance is 24 inches long without the fittings. The stamp on the back reads "23-3". The window was installed in 2007. ... (cont.)

I need a new crank mechanism for this old castle window.

The hardware says Entry Guard Truth and 20810

The metal channel is 25 1/2" long. It is stamped 25 2 B.S.I. pr I will need 4 of these.

Channel length is 13 1/2" It is stamped 13 2 B.S.I. pr I will need 6 of these.

Do you have this tilt latch in ur catalog ? I could not locate it. It's from a company called US Window Factory. Any help is greatly appreciated b thank you.

Only way to shut window is from outside. 45108 is on the inside along with patent number 4,840,075

These strips are in a groove on all side of each window painWe need 4 strips each 8 ft long

This part is a corner piece to a storm door window. It allows the wondow to tilt in. The picture shows the nipple broken off. It measures 1-3/4in. X 1-1/2 in. It is a little more than 1/8 in thick.

We have some windows that have missing cranks and am looking to replace them. This is a picture of what we have and would love for someone to help me decide which ones to order Thanks