Viewing all customer Discussions for:

Other

Need to replace window balancers on Andersen window. numbers appear to be D20 8#31 8 84 11600-17

The side brackets that contain the two rollers measure 3.16 long x 1.06 high x .69 wide. There are two rollers that measure 1.25 diameter. The center distance between the two rollers measures 1.69. The rollers are steel with roller bearings inside. I did take photos on my phone but I am sending thi ... (cont.)

We have 2 windows that just the locks have broken where you open and close them. Just the lever broke. Any ideas or suggestions to replace 2 sets?Thank you in advance.Chrissy

This is the only marking I could find on these doors. The sweep is now missing and I need a replacement. I know it is not a "typical" sweep and I am looking for some help in determining which sweep will work for the door.

I have Sears Weather Beater vinyl windowsThis is the bottom window of a small kitchen window 16.75" H X 32.25" W See: Bottom window Barcode.pngThe bottom window has a broken plastic channel spring guide on the right side (from the inside). I think Left and Right may be the same if the coil is rev ... (cont.)

we have 19 loewen doug fir aluminum clad french casement windows that were taken out of their frames in a remodel. They open out. The rabbit goes all the way across the bottom of the window. Consequently we only have the hardware in the photo below and not the slider track portion. AmesburyTruth id ... (cont.)

Hello,The photos are from the balance we are looking for. The top of the balanceis unusual from the typical sash balance. Please contact me with anyquestions.Thank you,John

Need 4 of these

Door is from around 1969 original to John Hancock building construction. Need qty 4.

The clip that holds window to frame?

Hello there I'm looking foe coil replacement numbers on the coil 9.0 rx43

Looking for the plastic piece it is broken on both sides of the window it locks the window

Balance are for simonton hurricane impact windows.

Sorry the picture is not clearer, you can see the lock on the left side better than the missing one on the right. I've looked at your site and am just not sure what the replacement part would be. Total lock length is approx 2 3/4 inches on a window that slides up and down. Thank you so much for an ... (cont.)

Looking for this part for a PGT vinyl window.

I recently bought four Truth Hardware Operator Covers and Folding Cranks in beige for my casement windows. They fit. Yay!!! (39-107 and 39-205)But I also need four of these lock sets to replace the ones I have. Each of these comprises two pieces. The part that is recessed into the frame is 4.5" l ... (cont.)

The T lock photo above is the part I am looking for. It appears to be a 15-236 but has a plastic brake shoe. The 15-236 has a metal spring brake. A 15-236 with a plastic brake from a 15-195B is what my part looks like. Is this type of T-Lock available? The white plastic part pictured above is from ... (cont.)

Looking for above part and is it easy to install

Seeking a pair of these parts

Hi, I need a few 1960's Stanley Rollers with these dimensions: Outside wheel dimension: 3/4" Inset of Roller over door: 1/4" thanks, Vinit