Viewing all customer Discussions for:

Weatherization

The weather strip is for the bottom window on a double hung The t slot is 3/16

I'm trying to locate replacement Pella weather strip and door sweep for three patio doors. The measurements appear to be 5/8 (but have been compressed over the years. The house was built around 2000 if that helps.

Hi. Can you help me identify what type of weather stripping I should use to replace this current one?

The window works perfectly is in summer all the mosquitoes and flyes come inside, the screen does not have any holes, the glass is perfect the vinyl casement are properly fitted, but the moment we open the windows the insects come, is the in between the windows, I have looked for something in all th ... (cont.)

Can the 36" door bottom (58-176) be cut to fit a 34" door? Is this threshold good for an exterior patio french door? What is the highest gap that will fit the seeps on this door bottom?

Looking for to purchase new window seals

I am looking for 1 locating pin that engages into the slide channel and 2 weatherstrip seals. The width is 35" Thank you for your help. Jon

I need a storm door sweep for Pella storm door model 3550 32 inch door. The Pella part number I believe is 33923, single expander sweep as listed on Pella's website. Do you carry this item and if so what is the price. Thank you for your assistance.

We have two sets of Pella patio doors on our home. One side is a door and the other is a stationary side window. It appears I need the 58-151 weatherseal push in bulb for the door side. Us this correct and what seal do I need for the window side? See attached photos.

the weather strip ripped..needs to be replaced

Hi - I could not locate a name or model number.

These seals in the two photographs have the following dimensions:1/2" wide1/4" kerf height1/8" kerf widthThe closest I see on your website that comes to this is Product Code: 58-055 9/32" Bubble Seal With Angled Base. It's not an exact match though. Which product would you recommend to replace the ... (cont.)

Can you point me to the hole cover and the weather stripping for this window? I am trying to refresh some of my windows. This one is probably the worst as the pivot bar was totally rusted in there. The rest of the windows should be better.

Good day, I uploaded a drawing of a door sweep I'm trying to replace from a Norco inswing door. I have a blurry photo of it installed but I don't dare remove it to photograph it as it may not go back on well. I'll upload the photo as well. Let me know if I can provide you with more information. T ... (cont.)

I need some front door weather stripping that looks like this.Ted

My name is Harold (Larry). I am enclosing five photos of a window sash that has the bottom seal deteriorating. The seal strip slides into a shallow, narrow grove on the outside face of the sash. The sash is white vinyl. I don't know the manufacturer, but one photo shows the label on the edge of ... (cont.)

2 piece vertical door seal for 6? wood frame sliding glass door. Door was installed early 1994. The picture with the number is on the actual door. The plastic seal is approximately 77? long

Hi, I'm looking for some weather strip for my lanai doors. I can't locate a brand name so I don't have that to help us. I finally located a full piece to measure and come up with 3/8 x 3/16. I did send this same note to your general mailbox but added pictures to this request. Thanks, Jim ... (cont.)

My second email after finding video about measuring it 5/16 diameter and the part that goes in the track is degraded bu t I estimate it to be about 1/4 inch. It is 28 1/2 inches wide .